Part Number: SN65C1167E Hi,
Please tell me about the TI RS422 driver/receiver: SN65C1167E.
The datasheet shows that VIH is 2 V (MIN), but it is OK to input a 3.3 V signal on 1D and 2D, right?
Vcc is assumed to be 5 V.
Thanks,
Conor
Part Number: SN65C1167E We are using SN65C1167E, given input on pin no.1 and pin 2.
Pin1: 100kHZ pulses (0V,5V)
pin2: ground
we see a undesired notch which is not in input(pin3)
figure attached for reference
Part Number: SN65C1167E Following connection I did:
PIN 16 VCC, PIN 12 DE ------ 5V ( from separate supply)
PIN 8 GND -------- GND ( from separate supply)
PIN 2 LSPWMN --------------- GND ( from microcontroller )
PIN 1 LSPWMP------------------ Pulse (…
Part Number: SN65C1167E I saw technical document (slyt441.pdf) for long-distance of SPI .
But only mention one slave in document(Fig3).
Can use SN65C1167E for long-distance of SPI w/ multi slave ?
Part Number: SN75160B Other Parts Discussed in Thread: SN65C1167E , hi Sir
Due to the SN75160B is the last time buy, I saw the alternatives parts is SN65C1167E
the two parts is the same?
i saw the data sheet is very different
please advise it,thanks
Part Number: SN65C1167E Dears,
Communication between boards using SN65C1167EPW. Under certain conditions Receive abnormal data.
When I investigated it, it was in the state of the attached file(schematic-SN65C1167EPW.jpg ). (Abnormal data occurs when SW1…
Part Number: ISO3086T Other Parts Discussed in Thread: AM26LV32E , ISOW7840 , ISOW7740 , AM26LV31E , AM26C31 , AM26C32 , SN65C1167E Hi team,
As show in blew picture, the four single-end SPI signals need to be transferred to differential signals after isolated…