Part Number: SN65HVD01 Hi,
Is it possible to finalize Test orders manually or do they need to complete the document flow ?
Could you send us an example of a delivery note between TEXAS -IKOR ?
Part Number: SN65HVD01 Hi Support,
We use SN65HVD01 IC on my project, we will generator the signal and connect to pin 5 of SN65HVD01.
According to IC spec, the VIL range is 0~0.3*VL (VL is 3.6V) ==> 0~1.08V, we have measure the waveform as follows:
…
Part Number: SN65HVD01 HI.
I designed using SN65HVD01 parts in my design.
In my design I have Chassis ground and signal ground.
I separated the pcb layout using a capacitor and a resistor.
At this point, want to place the capacitor in each Mounting…
Part Number: SN65HVD01 I measured A with an oscilloscope.
Setting
* VCC, VL = 3.3V
* nRE / DE = Pull up (3.3v / 6k Ohm)
* Terminator Resistor = Side 120 Ohm
Ch 1 = SN65HVD01 R Digital Output (2pin)
Ch 2 = SN65HVD01 A Bus I/O
The timing is correct,…
Part Number: SN65HVD01 I want to know the communication distance according to the voltage supplied to the Transceiver.
- Is there a difference in communication distance between 3.3v and 5v?
- What is the maximum communication distance when the supply voltage…
Part Number: SN65HVD01 Spec
: SN65HVD01 (power Supply 3.3v)
: Cable awg 24 (twist + shield)
: data rate 200kbps under
: Stub line 1 (1:1 communication)
1) What is the maximum cable length that can be RS 485 communicated in the above situation?
2 …
Part Number: SN65HVD01 Other Parts Discussed in Thread: SN65HVD10 Hello,
I am having a new question about the SN65HVD01 transceiver :
Considering 2 transceivers very close together, in the same environment (identical temperature and power supply). Is…
Part Number: SN65HVD01 Other Parts Discussed in Thread: THVD1500 , THVD1410 Hi Sir
May SN65HVD01 can take signal from RJ45 and the get Differential signal transfer to Single-Ended?
or there have other suggestion part?
…
Part Number: SN65HVD01 Hi dear supporting team,
customer is using SN65HVD01, want to need double check with you:tks!
the Vl=1.8V, VCC=3.3V, when Vl=1.8V shows up, but Vcc 3.3v is not supplied, i.e. Vcc=0V, will it cause damage?
Part Number: SN65HVD01 Hello team.
I have been asked if a pair of SN65HVD01 would be compatible with an HDLC datalink protocol. I am not sure about the answer so i come for you. Could you please enlighten me ?
Have a good day,
Tom