Answered

• SN65HVD1050A-Q1: Cannot induce dominant bus state

  

  Matthew Anauo

  Resolved

  Part Number: SN65HVD1050A-Q1 Tool/software: I'm working on a board where the CAN transceiver is being tested in isolation (benchtop 5V power applied for supply, no microcontroller connected to TX/RX so lines are being manually tied high/low to 5V/GND…

  • Resolved

  • over 1 year ago
  • Interface
  • Interface forum
Answered

• SN65HVD1050A-Q1: About the Vref

  

  Yuhao Wang

  Resolved

  Part Number: SN65HVD1050A-Q1 Other Parts Discussed in Thread: TCAN1057A-Q1 Hello, Our customer got a question about if it is possible to connect pin s to the ground and connect nothing to the Vref pin. If they connect the Vref pin to the ground how…

  • Resolved

  • over 1 year ago
  • Interface
  • Interface forum

• SN65HVD1050A-Q1: SN65HVD1050A-Q1 replace TJA1050T

  

  Jimmy WANG

  TI Thinks Resolved

  Part Number: SN65HVD1050A-Q1 Other Parts Discussed in Thread: TCAN1051-Q1 Hi Team, My customer use TJA1050T that I found SN65HVD1050A-Q1 can replace it (P2P) But TI website show TCAN1051-Q1 a similar device. ( Same functionality but is not pin-for…

  • over 4 years ago
  • Interface
  • Interface forum

• SN65HVD1050A-Q1: Vref Floating

  

  Cedrick

  TI Thinks Resolved

  Part Number: SN65HVD1050A-Q1 Other Parts Discussed in Thread: TCAN1051-Q1 Hi, Good day. I hope you are doing fine. Our customer is using the SN65HVD1050A-Q1 and they want to know if they can left the Vref pin floating. Will it work? I hope you could help…

  • over 4 years ago
  • Interface
  • Interface forum

• SN65HVD1050A-Q1: TJF1051 replacement

  

  Mihir Gupta65

  TI Thinks Resolved

  Part Number: SN65HVD1050A-Q1 Other Parts Discussed in Thread: TCAN1051 Hi Team, do you have a suggestion for a replacement for the NXP TJF1051 ? Could the SN65HVD1050A-Q1 work here? Regards Mihir

  • over 6 years ago
  • Interface
  • Interface forum

• SN65HVD1050A-Q1: Does this part need a common mode choke of filtering ? Can this IC stay unpowered without causing CANBus distortion or loading ?

  

  Ajeya Anand

  TI Thinks Resolved

  Part Number: SN65HVD1050A-Q1 Other Parts Discussed in Thread: TCAN1051-Q1 , I am using this with my car OBDII port, to get info from it. Does this chip need any additional filtering circuit like a common mode choke ? or terminating resistor ?

  • over 7 years ago
  • Interface
  • Interface forum
Answered

• SN65HVD1050-Q1 / SN65HVD1050A-Q1 / SN65HVDA1050A-Q1

  

  K.Yaita

  Resolved

  Other Parts Discussed in Thread: SN65HVD1050-Q1 , SN65HVD1050A-Q1 , SN65HVDA1050A-Q1 Hi Team, My customer consider to use CAN tranceiver for automotive application. I found following 3 devices. 1) SN65HVD1050-Q1 2) SN65HVD1050A-Q1 3) SN65HVDA1050A…

  • Resolved

  • over 11 years ago
  • Automotive (Read-Only)
  • Automotive Forum (Read-Only)
Answered

• VRef output of SN65HVD1050A-Q1

  

  John Connors

  Resolved

  Other Parts Discussed in Thread: SN65HVD1050A-Q1 Hello, I am working on a design using the SN65HVD1050A-Q1. The datasheet does not say much about the Vref pin on the part, but does show a couple case where it is attached to a cap to ground. My questions…

  • Resolved

  • over 14 years ago
  • Automotive (Read-Only)
  • Automotive Forum (Read-Only)

• SN65HVD1050: SN65HVD1050

  

  Barry Haworth

  TI Thinks Resolved

  Part Number: SN65HVD1050 Other Parts Discussed in Thread: , , TCAN1051 Please can someone tell me what the differences are between the three CAN transceivers sn65hvd1050, sn65hvd1050a-q1 and sn65hvd1050-q1. Basically our supply chain department has inadvertently…

  • over 4 years ago
  • Interface
  • Interface forum

Didn't find what you are looking for? Post a new question.