Part Number: SN65HVD234 Tool/software: Hello Few years ago, our purchase team bought a TI CAN Transceiver(SN65HVD234) from 2 different distributors, one is Mouser(TI authorized distributor) and the other is TI unauthorized distributor.
And recently…
Part Number: SN65HVD234 Tool/software: After making some changes to our CAN harness, we tested the CAN bus and were getting these measurements. Is this within the acceptable quality range? If not, how much would the waveform have to change to fall within…
Part Number: SN65HVD234 Tool/software:
I am using CAN to communicate to motors. When the motor has high current, we see an overshoot in the differential waveform, which is figure 14. Figure 9 is low current in the motor. We don't see the same behavior…
Part Number: SN65HVD234 Tool/software: Hi,
I am reading application report "SLLA337", which is related to 3.3V CAN.
Several questions:
1. To minimize EMC, I need to keep the common mode voltage of CAN bus recessive state same as dominant state,…
Part Number: SN65HVD234 Tool/software:
I have a three board Industrial Automation CAN demo (MN04, SN04 and SM04). They are all labeled "Sensor Node CBSN-1 and CBSM-1" in the copper. DB9 interconnections for the CAN BUS. The CBSM-1 appears to be the…
Part Number: SN65HVD234 Other Parts Discussed in Thread: TCAN1057A-Q1 , TCAN1044A-Q1 Tool/software: Hi TRX team,
I am looking for a replacement for SN65HVD234D, with the following requirements:
- As small as possible;
- Robustness ±58V (CAN high…
Part Number: SN65HVD234 Other Parts Discussed in Thread: THVD1439 , TCAN3414 , SN65HVD231 Tool/software: We want to parallel the A/B output of a THVD1439 and the output of the SN65HVD234 CAN transceiver so either standard could be available on our two…
Part Number: SN65HVD234 Tool/software: Typically we should have two 120 Ohm termination for the CAN interface at the end points of the CAN network. What we found was the previous design had a total of 3x 120 Ohm termination. Can you please let me know…
Part Number: SN65HVD234 Tool/software: Here is the differential waveform that we measured near the CAN transceiver. This is measured using a differential probe probing CAN_H and CAN_L. We see the glitch on the falling edge and ringing on the rising edge…
Part Number: SN65HVD234 Other Parts Discussed in Thread: TMS320F280025C , , ISO1042 , ISOW1044 , ISO6721 , ISO1044 We are using the TMS320F280025C launchpad with the 8770EVM gate driver to build a multilevel output, however the CAN tranceiver does not…
