I want to use a re-driver between Hub controller(TUSB8040A1) and USB connector(PC)
Below picture. ==> SN65LVPE502A
Which choice is good?
1. SN65LVPE502 TypeA or B or SN65LVPE512
2. which side is right direction?
- Which side is the host ?
TUSB8040A1…
Hello RE
Our customer needs IBIS model of SN65LVPE502. Has IBIS been generated ? Please provide it.
Your reply would be appreciated. Thanks and best regards.
Other Parts Discussed in Thread: SN65LVPE502 , SN65LVPE502CP a) It is my understanding that the SN65LVPE502CP actually supports the CM Mode functionality of the earlier SN65LVPE502 part, even though the datasheet labels the CM pin (Pin 14) as RSVD. Please…
Other Parts Discussed in Thread: SN65LVPE502 Dear Technical Support Team,
Can each channel of USB 3.0 redriver IC ( SN65LVPE502) be used independently? I was thinking to use this IC for different purpose (transmitting data other than USB 3.0 data), my…
Dear Undrea
Thank you for your reply.
I confirmed the customer.
Between EZ-USB and repeater is connected USB3.0 cable,
EZ-USB Tx and repeater Rx, although the impedance is 83kohm, EZ-USB changed SuperSpeed.
Repeater Tx and EZ-USB Rx is still Rx Detected…
Hi Gerardo-san and Team,
Our customer had tried using SN65LVPE512EVM instead of SN65LVPE502. However, there were no differentiation to the compliance test.
USB 3.0 Compliance Test : TD9.23 could be passed if SN65LVPE502B is bypassed, so the device is…
Other Parts Discussed in Thread: SN65LVPE502 a resolve way about usb3.0 device by TMS320C6A816x:
TMS320C6A816x's PCIe interface - SN65LVPE502- USB connector ------- Cable--------USB3.0 Host ( PC ).
TMS320C6A816x's PCIe interface and SN65LVPE50…
Hello,
I came across SN65LVPE 502 EVM, which also has a board schematics.
1. I will be using SN65LVPE 512 in my application. Can I use the 502 board schematic as a reference to my design?
There is something I`m not so sure about at the 502`s board schematics…