Part Number: TCAN1042G-Q1 Tool/software: Hi Team,
Customer would like to put TCAN1042 back-to-back on the board, it means that one device put on top and the other put on the bottom, CANH and CANL connect by vias. Is there any problem with such layout…
Part Number: TCAN1042G-Q1 hi
In a project of our company, CAN chip TCAN1042GDRQ1 of TI company is used for CAN bus communication. When testing CAN communication, CAN communication frame waveform is found as follows. Please kindly answer: There are voltage…
Part Number: TCAN1042G-Q1 Hi, team,
Can you help check what is the internal pull-up resistor for TXD/RXD? My customer would like to get the resistor value for system evaluation.
Thanks.
Johnny
Part Number: TCAN1042G-Q1 Other Parts Discussed in Thread: TINA-TI Hello!
I have been trying to do some simulations with TCAN1042 and the first thing i wanted to get a normal setup working.
I took the TCAN1042 TINA-TI Transient sim from the product folder…
Part Number: TCAN1042G-Q1 Other Parts Discussed in Thread: TCAN4550-Q1 Hi Team,
There is a good new that DIN TCAN1042
If the CANH and CANL trace are not the same exact length what will it impact? Will it cause any significant impxct?
TCAN1042: CANL = 1495mils…
Part Number: TCAN1042G-Q1 Other Parts Discussed in Thread: TCAN1044V Hi Team,
There is a good new that DIN TCAN
1. There is currently an opportunity to replace TJA1042TK/3-118 , is there a recommended solution?
2. please provide comparison table,THX
…
Part Number: TCAN1042G-Q1 Hi，TI
TJA1042 in the attached picture actually uses TCAN1042DRQ1.
Figure 1 shows the CAN circuit of our controller, and Figure 2 shows the CAN circuit of our peripheral board. It is required that a set of CAN circuits (red box…
