Part Number: TCAN1044A-Q1 Other Parts Discussed in Thread: TLIN1022-Q1 , TLIN1021A-Q1 Hi team,
Customer wants to know if the our CAN/LIN device has short to battery/GND diagnostic.
I searched in datasheet but found nothing.
Regards,
Peter
Part Number: TCAN1044A-Q1 Hi All
Problem description :1044TCANA should be able to maintain normal communication under CANH short Vbat or CANL short ground, but during our debugging process, Busoff will occur when CANH short Vbat or CANL short ground…
Part Number: TCAN1044A-Q1 Other Parts Discussed in Thread: TCAN1043A-Q1 , TCAN1043 Our client encountered some non reproducible issues while using tcan1043A-Q1, and we are actively tracking and resolving this issue. But for the customer, they would like…
Part Number: TCAN1044A-Q1 Other Parts Discussed in Thread: TCAN1044AV-Q1 , ESD2CAN24-Q1 Hi,
Based on this figure, could please recommend the output capacitor and ESD selection? Will these be different when CAN speed rate is different?
Part Number: TCAN1044A-Q1 Other Parts Discussed in Thread: TCAN1044AV-Q1 , , TCAN1042-Q1 Please mention what is the difference between TCAN1044AV-Q1 & TCAN1044A-Q1.
Also please confirm if TCAN1044A-Q1 is p2p with TCAN1042-Q1.
Part Number: TCAN1044A-Q1 Dear Team,
I'm using TCAN1044ADRQ1 IC in my project. I have small doubt on the transceiver.
1. Is the Short-circuit steady-state output current, dominant Normal mode {IOS(SS_DOM)} of 115mA is the maximum limiting current…
Part Number: TCAN1044A-Q1 Hi Expert,
Customer report an issue for TCAN1044A-Q1 that it will detect the error frame at heavy load(>90%) communication. The test procedure as below.
Repeat the IG ON/OFF test(turn on/off CAN communication), the error frame…
Part Number: TCAN1044A-Q1 Hi team,
As the regular CAN system design, there will always be a single 120-Ω resistor at each end of the bus. And the customer want to make sure one thing: if the end TCAN1044 has been broken or removed, is there any other influence…
Part Number: TCAN1044A-Q1 Hi team,
My customer is using our TCAN1044ADRQ1, the voltage from MCU is 3.3V.
Since our TCAN1044ADRQ1 don't have VIO pin, in theory the voltage on TXD & RXD should be 5V,but they didn't find any abnormal with 3.3V.…
Part Number: TCAN1044A-Q1 Other Parts Discussed in Thread: TCAN1462-Q1 Hi team,
Customer would like to know if we could share RXD internal structure for TCAN1044A-Q1 and TCAN1462-Q1? Is it push pull or open drain? Whether we have internal pull up or pull…