Jonathan Nerger said: However the max wetting current level of 15mA, would give you about 15mV of voltage difference for each ohm of resistance which is approximately equal to 3 ADC codes. The maximum resistance of 300 ohms would result in 4.5V at the…
Part Number: TIC12400EVM-KIT
Hi,
I am using TIC12400EVM - Kit. I want to interface microcontroller with this kit to detect the switch status.
Here SPI protocol is used for getting the status. How to configure the SPI protocol in TIC12400EVM - Kit?
…
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400 Hi TI ,
Here we Did the Setup The TIC12400 With External MCU, Using The SPI Lines of RH850 Controller,
Here is the Following connection details .
RST is Conected with GND.
MOSI is…
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400-Q1 , TIC12400 Hi, Support Team
We use TIC12400EVM have two question:
Below have two chart, we do not fine tune the switch, but read value is different?
and other mode, we also do not…
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400 Hi, Support Team
Could share example code aout TIC12400?
If any, Please advise me.
Thanks,
Best regards,
Lawrence
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400 Hello TI experts,
My customer wants to test TIC12400 using EVM, but it is out of stock now.
https://www.ti.com/tool/TIC12400EVM-KIT
When can I order this EVM? can you check the schedule…
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400 , TXB0106 , TIC12400-Q1 Hi I am new with MSDI & trying to interface TIC12400Q1 EVM SPI Communication with External Microcontroller(NXP: S32K118) So i am transmitting 0x02000000 (DEVICE_ID…
Part Number: TIC12400EVM-KIT Dear Team,
Do we provide the source code to enable customers to build their own code to test the system with their own MCU?
Best Regards,
Caglar
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400 Hi TI-team
I want to connect the STITCH BOARD to the TIC12400EVM-KIT and check the operation. I have read the TIC12400 EVM User's Guide but it does not work well.
There is no…
Part Number: TIC12400EVM-KIT Other Parts Discussed in Thread: TIC12400-Q1 I am trying to configure the device in sleep mode so that any switch state change it gives interrupt to MCU
and for interrupt mode, the trigger is required or not. what is the proccess…