Part Number: TLK10034 Other Parts Discussed in Thread: TLK10232 , , TLK10031 Tool/software: Hello,
I am trying to ascertain the following for the TLK10034, TLK10031, and TLK10232 series PHYs.
1. Will the PHYs support both 10GBASE-KR and 1000BASE-KX…
Part Number: TLK10034 The data sheet did not provide power design information. Is there a app note, design guide or reference design you could send me with recommendations?
Is a separate regulator needed for the analog core?
Would a single supply…
Part Number: TLK10034 Other Parts Discussed in Thread: MSP430F5529 Hi
I am trying to use USB-2MDIO GUI to talk to TLK10034. The LaunchPad I use is MSP430F5529.
I connect external 1.8V to the MSP430F5529.
When I try to read or write through GUI,…
Part Number: TLK10034 Hello,
My customer is asking if there are register settings that can be read that provide the RX adaptive equalization settings being applied to the device. I see that bits 11:8 in register 0x0008 correspond with LS Serdes Equalization…
Part Number: USB-2-MDIO Other Parts Discussed in Thread: TLK10034 , MSP430F5529 Hello,
My customer is looking to use the USB-2-MDIO GUI and MSP430F5529 LaunchPad to communicate with TLK10034. They're able to read registers from the TLK10034, however…
Part Number: TLK10034 Hi,
We are looking for a Quad Port XAUI to 10GBASE-R/XFI converter device for below application,
Processor/MAC with XAUI interface <---> TLK10034 with XAUI interface at host side & 10G-BASE-R at line side <---> Mult-rate…
Part Number: TLK10034 Other Parts Discussed in Thread: TLK10232 Hello,
I am using the TLK eval board.
There is 4 10G channel available with my board (Lane A, B, C and D).
My objective is to use 10GBaseKR, with autoneg and training.
When i loopback…
Part Number: TLK10034 Hello support team,
We are having problems communicating with TLK10034.
The component does not respond when we are trying to access the MDIO bus. Do you have any suggestions on what might cause this problem?
On our board the…
Part Number: TLK10034 Are there any common 10G performance issues root caused to part handling? We continue to see high variance in packet errors CCA to CCA.
I recommend to use the AMI model and setup the MB203 to be located as it is in the middle of the 10G-KR link. With this topology you can have a channel segment before and after the repeater model.
Regards,
Lee
