Part Number: TLK1221EVM Hello,
We have a customer who is asking the following:
"I am looking for the EVM which can generate PRBS7 down to 10Mb/s data rate. Do you have such product avaiable? We used TLK1221EVM Evaluation Module before, however its supported…
Other Parts Discussed in Thread: TLK1221 , TLK1221EVM Hello Guys,
Good day!
We have a customer looking for a wireless Ethernet transceiver that a SERDES IC can send data in and out at 100 Mbps. In the TLK1221 EVM of the figure below, instead of the loop…
Hi Yusuke,
The customer could take the TLK1221EVM as a reference:
www.ti.com/.../sllu100.pdf
I hope this helps.
Regards,
Luis Omar Moran
High Speed Interface
SWAT Team
Hi Michael, The recommended value for RXP/N & TXP/N is 0.01uF (most of applications). In the page 13 the value of 5pF was a specific case for test setup, in my understanding is the minimum value for these caps. Even you could take the TLK1221EVM (similar…
Hi Paul, Have you tried the configuration of our TLK1221EVM (Page 9B)? www.ti.com/.../sllu100.pdf
Output impedande value is not specified in datasheet but it should be in the 30 - 50 Ohm range. As well, V(CM) Receiver input voltage requirement, VID…