Part Number: TPL0401A-10-Q1TPL0401A-10-Q1 Can this potentiometer be placed in the middle of the CAN signal as a terminal resistor?If not, please give me other suggestions, thank you!
Part Number: TPL0401A-10-Q1 Other Parts Discussed in Thread: TCA9537 Hello,
are the timing requirements in the table chapter 7.6 requiremens to the master µC that the TPL0401 will undestand the messages or is it just the timing, that the TPL0401 will generate…
Part Number: TPL0401A-10 I am trying to read & write to the wiper register as per instructions in datasheet using i2c_read_device function in python pigpio library. The read command returns b'\x7f\xff\xff\xff....' instead of the powerup default expected…
Part Number: TPL0401A-10 Hello expert,
My customer would like to know the start up requirement on the timing. They faced some issue is between VDD and external resistor pull high voltage. So they would like to know if you have timing requirement between…
Part Number: TPL0401A-10 Other Parts Discussed in Thread: DAC43701 Hello team,
the customer has asked a replacement solution for their currently used Single Digitally Controlled Potentiometer ISL95810UIU8Z-T (Rensas), .
TI does not have a direct pin-to…
Part Number: TLV320AIC3109-Q1
Hi, Support Team
about TLV320AIC3109-Q1, if Input 8V(MEMS MIC)connect to PIN10, have any concern?
if cannot, how to fixed input high voltage MIC connect to TI audio codec?
schematic as below chart:
Analog MIC specification…
Part Number: DRV8906-Q1 Hi team,
My customer is using our DRV8906/08/10/12-Q1.
Could you please kindly help check if they can drive stepper motor?
If they can, please kindly help check what need customer to pay attention to.
If not, please kindly help…
Hi Will,
Will Gao said: Recently they added some codes (just some logic but not modify the hardware registers) in core 1-0's project.
1. Can you please give some more information about this. Is this something being run from the SDK SDL diagnostic functions…
Part Number: INA228-Q1 Other Parts Discussed in Thread: TCA9543A , TCA9548A , Hello there,
I'm currently looking at addressing 150 INA228-1Q devices.
Therefore I'm hoping to use 10 Bit target addressing, is the possible with this chip?
Thanks in…