Hi Anthony,
I'm actually thinking to put TPS2540 right after the TUSB1105. I'll do more research and maybe seek help on the Power Interface forum.
Thank you
Derrick
Other Parts Discussed in Thread: TUSB1105 , RM48L952 , RM48L950 We are implementing TI # TUSB1105 on our module. On the RM48 HDK schematic, there appears to be 10K pull-up resistors on USB.SUSPEND and USB.RCV from the MCU. Are these needed? Are any additional…
Hi Rustin,
The RM48x Hercules Hardware Development Kit utilizes the TUSB1105 USB transciever. The product folder can be found here: http://www.ti.com/product/tusb1105
The RM48 HDK is described in more detail here, should you be interested in the relevent…
Other Parts Discussed in Thread: TUSB1106 , TUSB1105 Hello,
I was asked about the explanation of VCC(I/O) on the datasheet from customer. In the page 4, VCC(I/O) must never exceed the Vreg(3.3) voltage. In the page 6, Sharing mode is VCC(I/O) connected…
Other Parts Discussed in Thread: TUSB1106 , TUSB1105 , RM46L852 Hi,
We are setting up USB host on RM46L852PGE and getting troubles to understand some pin functions and how to use them. There is a pin named as USB2.TXDAT which is described in the datasheet…
Other Parts Discussed in Thread: TUSB1105 , TUSB2551A , TUSB2551 I have a 4 pin FS USB interchip serial interface on my OMAP processor normally used for communicating with a SIM card that a customer wants to use for an external FS USB interface.
The…
Other Parts Discussed in Thread: TMS320VC5416 , TUSB1105 , TUSB3410 Hi everyone,
I need to make USB communications for my DSP (TMS320VC5416) and want to know if the TUSB3210 is the interface to use, or just a TUSB1105 transceiver. I'm assuming with…
Does the PSP now support OHCI for the AM3715? The ECHI to OHCI errata has forced us to use this route so we are also looking at using the OCHI controller and the TI TUSB1105 PHY. But will the PSP support this mode?
The AM37xx is affected by an errata in this area:
Advisory 1.113 USB HOST: Impossible To Attach a FS Device To An EHCI Port - Handoff To OHCI Is Not Functional
Ramakrishna or anyone else:
Did you have success putting Port 1 or 2 into OHCI mode…
