Dean,
I appreciate the reply and might expect the 0.1" pitch headers to be a 235 mil "standard" post height but the 0.05" pitch is much more difficult to find standards for.
I'd love to at least see post length for the pins I hope to connect to an…
Hi Saril,
The SN65LVCP408 outputs are not compatible with the PCIe clock standard. I would suggest using the LMK00334 or LMK0338 for switching and buffering the PCIe clock. The CDCI6214 is a good choice for PCIe clock generation.
Regards,
Lee
Hello Cafain,
The LMK04816 operated in single-loop mode should behave similarly to the Lattice device, with some notable exceptions:
3.3V operation only (this will be true of nearly all TI devices with a comparable number of outputs)
SSC input…
Hi Yuanqing,
Any fractional PLL, which can support your required input and output frequencies can be useful for your application.
CDCEL824 may have limited Xtal input frequency start from 10MHz, which may not support 9.6MHz inputs, else it can be…
Part Number: CDCE6214 Tool/software: Hello expert,
May I know the programming times limitation for CDCE6214? For other solution from other product line, we can only program device twice. So we would like to know how many times we can program CDCE6214…
Hello Matsumoto-san,
Please review the TICS Pro 1.7.0.0 release notes (attached, below). The complete list of changes starts at item 5.30 and extends to the most recent release at 5.34. There are several changes to LMK05318 device profile, intended…
Hi Howard,
I'm afraid we don't have phase noise plots other than the ones available in the datasheet. As for the drive level, you can add a series resistor if the drive level is too high, because normally crystal's max drive level is 100uW or 200uW…
Part Number: SK-AM69 Other Parts Discussed in Thread: J721EXENETXPANEVM , , AM69 Tool/software: Hello,
we want to use the J721EXENETXPANEVM Quad ETH expansion card with our SK-AM69 dev kit. We know this combination is not yet suppored, but according…
Part Number: CDCI6214EVM Other Parts Discussed in Thread: USB2ANY Hi,
I'm trying to load my TICS Pro file onto my CDCI6214EVM board, the "USB2ANY" is connected and green, but when toggling the "PWR on/off" button, I get the "No Device Found!" pop-up…
