NIKET AGRAWAL said:
At present I'm using the MSP-TS430PN80 target board with MSP430FETUIF Debugger on CCSv5.
I just more closely looked at your post indicating the use of the MSP-FET430UIF tool. Unfortunately, that particular tool does not support…
Other Parts Discussed in Thread: MSP-TS430PN80 , MSP430F5418 configuration used:-
code composer studio core edition Version: 4.0.2.01003
board MSP-TS430PN80
debug interface MSP-FET430UIF
micocontroller used MSP430F5418
any solutions??
Other Parts Discussed in Thread: MSP430F5529 , MSP-TS430PN80USB Hi all,
Just looking for help with my CCS -> FET. The details of my installation are:
Fresh, clean installation
version 5.4.0.00091
Host is Ubuntu 13.04 laptop. Linux command 'lsusb' shows…
Other Parts Discussed in Thread: MSP430F5529 , ENERGIA , L293D , CC3100 , MSP-FET , LP2950 , LM2576 HI. My name is Ibrahim Shofiquel. I a Computer Engineernig student graduating in the next two weeks. We have a capstone senior design course and i am trying to…
Hi aBUGSworstnightmare-san.
Thank you for your comment and information.
But MSP-TS430PN80 that you suggested was different pin assignment with actual device MSP430F5435.
Actual device MSP430F5435's RST/NMI is No.76pin. But MSP-TS430PN80's RST/NMI is…
Other Parts Discussed in Thread: MSP430FG437 , MSP-TS430PN80 can anyone tell me what the following code is doing ?
/* Configure DAC 0 to provide variable drive to the LEDs */ DAC12_0CTL = DAC12CALON | DAC12IR | DAC12AMP_7 | DAC12ENC; // VRef+, high speed…
Other Parts Discussed in Thread: MSP-TS430PN80 , MSP430F5529 Hello,
In order to burn Segment C in the information flash I run the following code:
while (FCTL3 & BUSY); //Check busy bit FCTL3 = FWKEY; //clear lock bit FCTL1 = FWKEY + ERASE; //set erase…
Thank You sir.
I am a newbie in this field. so please pardon my mistakes
My evaluation board is MSP-TS430PN80 and it doesn't have any external crystal.
I understood why LFOF Bit is still set from your answer.
Thank you for spending your valuable…
Thank you for your reply, Andreas.
>I would suggest double-checking your HW setup first. When configuring your code for A1 operation, can you put a >multimeter directly on the device pins 63 and 64 to measure the voltage there? Is it as expected…