Part Number: TPS65910
Hi
Is there any efficiency and thermal estimator tool for TPS65910 PMIC? or is there any graph available for efficiency vs load current for BUCKs and LDOs?
Part Number: TPS65910 Hi support team, This is a question about TPS65910A31A1RSLT.
14pin: At SWIO output +1.5V, supply destination device (CPU, DDR3 SDRAM) input conditions (MAX side: 1.575V) were found to be just at the limit.
A 10uF bypass capacitor…
Part Number: TPS65910
Hi team,
Our customer want to start this device with push button on connected PWRON pin after input voltage is applied.
In below E2E question, it is said Applying input voltage is enough to start the PMIC.
https://e2e.ti.com/support…
Part Number: PROCESSOR-SDK-AM335X Other Parts Discussed in Thread: TPS65910
Hi Team,
In order to pull down the voltage of vdd_mpu from 1.35V to 1.26V.
I try to use I2C to modify register of TPS65910 but it's shown "Error: Could not set address to 0x2d…
Part Number: TPS65910 Hello, Datasheet 6.2 says VAUX2 power is 150mA. But, datasheet 5.20 says VAUX rated output current Iout(max) is 300mA (minimum). Which is correct? Best regards, K.Hirano
Part Number: TPS65910 Other Parts Discussed in Thread: AM3354 Hi,
In the datasheet, there is inrush specification in LDO characteristics table.
Does it mean that when TPS65910 is designed with AM3354, each LDO show those inrush current at start-up?
Is…
Part Number: AM3356 Other Parts Discussed in Thread: TPS65910 Hi TI
As the title states, the customer is removing the PMIC TPS65910 and redesigning and validating the system based on Discrete DCDC/LDO. However, it was stopped after leaving the log below…
Part Number: TPS65910 Other Parts Discussed in Thread: AM3354
Upper picture is TPS65910's User Guide 3 page.
Hi !
I use a AM3354 and TPS65910A3A1.
I want to know about TPS65910A3A1's output voltage.
And No.14pin, SWIO pin, I think there are no…