Frequent Questions

  • [FAQ] If the OE pin is asserted to maintain Hi-Z at the IO, will it disconnect the internal pull-up resistors in TXS devices?

    FAQ: Logic and Voltage Translation > Voltage Translators >> Current FAQ Yes, the internal pull-up resistors are disconnected once OE is asserted(to enable High impedance on the IO ports) Additionally, if the device supports Vcc isolation feature …

  • [FAQ] TPS65381A-Q1: Is there a power estimator for the TPS65381A-Q1?

    Part Number: TPS65381A-Q1 Is there a power estimator for the TPS65381A-Q1?

  • [FAQ] How do you set current limits and voltage thresholds in your system using digital input modules?

    Other Parts Discussed in Thread: ISO1212 , ISO1211 How do you set current limits and voltage thresholds in your system using digital input modules?

  • [FAQ] In high channel count designs, how do I reduce the number of digital connections to the MCU?

    In high channel count designs, how do I reduce the number of digital connections to the MCU?

  • [FAQ] Is there reliability fit data available for the ISO1211 and the ISO1212 digital input receiver devices?

    Is there reliability fit data available for the ISO1211 and the ISO1212 digital input receiver devices?

  • [FAQ] How do you isolate multiple digital input channels with limited board space?

    Other Parts Discussed in Thread: ISO1212 How do you isolate multiple digital input channels with limited board space?

  • [FAQ] How do you provide an LED status indicator with ISO121x digital input receiver devices?

    How do you provide an LED status indicator with ISO121x digital input receiver devices?

  • [FAQ] TPS23880: How to update TPS23880 firmware and how to detect what firmware version I am currently running?

    Part Number: TPS23880 How to update TPS23880 firmware and how to detect what firmware version I am currently running?

  • [FAQ] UCC5310: App note describing about Miller clamp feature

    Part Number: UCC5310 Hi Team, Do you have any app note describing Miller clamp feature? I especially want to know following two points. 1. What is Miller clamp? 2. how does our Miller clamp function work? Regards, Takashi Onawa

  • [FAQ] How do I make an op amp circuit stable?

    Other Parts Discussed in Thread: 4213 The attached presentation details how to make many common op amp circuits stable. 4213.Solving Op Amp Stability 2015_TG.pptx

View FAQ threads
Recommended For You