Other Parts Discussed in Thread: GAUGEPARCAL , GPCCEDV Tool/software: How do I get started with CEDV gauges?

Part Number: AM62L Tool/software: The FAQ is on how to configure DDR as 256MB to boot Linux on AM62L EVM

Part Number: AM62L Tool/software: AM62L ROM supports boot from ONFI 1.0 compatible 8-bit parallel NAND memory of 2Gbytes or less in size connected to GPMC CS0 with the following geometries and features • 2Kbyte page and spare area of at least 64 bytes…

Part Number: AM62L Tool/software: AM62L ROM supports boot from ONFI 1.0 compatible 8-bit parallel NAND memory of 2Gbytes or less in size connected to GPMC CS0 with the following geometries and features • 2Kbyte page and spare area of at least 64 bytes…

Part Number: AM62A7 Tool/software: I want to develop CSI camera based applications on AM62A. What are the supported CSI cameras on AM62A?

Part Number: SK-AM62A-LP Tool/software: I have a Raspberry Pi camera module 2 (IMX219). How can I use it with the AM62A SK EVM?

Part Number: J784S4XEVM Tool/software: On 10.x SDK how can we revert the DDR configurations done in R5 SPL to 9.2 SDK?

Part Number: MCU-PLUS-SDK-AM243X Tool/software: Hi Team, I am doing development on AM243x SoC, and ran into issues with the resource allocation. Is there any tool/script like K3conf which runs on Linux Environment? Since, I can't use Linux on my…

Part Number: AM2612 AM263P4 Other Parts Discussed in Thread: UNIFLASH Tool/software: Note: Valid for only AM263Px and AM261x devices Hi Expert, How do I add custom flash programming support in Uniflash tool using MCU PLUS SDK.

Part Number: AM625 Tool/software: Hi, I would like to know if the AM6352 continuously maintains the eMMC clock or if it stops it when it finishes the read and write processes. Why asking ? In most eMMC the “patrol” that refreshes and monitors…