DRV110EVM: Request for physical dimension of mounting hole for DRV110EVM

Jonathan Geronga

Part Number: DRV110EVM

Hi Team,

Our customer would like to request the physical dimension of mounting hole for DRV110EVM to use for fitting.

I found related thread but only the board dimension is given:
https://e2e.ti.com/support/motor-drivers/f/38/t/703111

If you can share also the 3D model, the customer appreciates it more.
Please let me know if this information can be shared offline so I will just send an email.

Thanks,

Jonathan

over 5 years ago

0 Costin Cazana over 5 years ago

TI__Expert 4940 points

Hi Jonathan,

I have notified our expert regarding this topic, Please expect a response by 6/16/20.

Thanks,

Costin

0 Costin Cazana over 5 years ago in reply to Costin Cazana

TI__Expert 4940 points

Hi Jonathan,

I think you're looking for mounting hole diameter and board thickness. I'll get back to you

Regards,

Costin

0 Jonathan Geronga over 5 years ago in reply to Costin Cazana

TI__Expert 7930 points

Hi Costin,

Thank you for your response and support.

Yes, This should be part of the request. And I think the location of the mounting holes in the edge of the PCB.

But all the information you can share will be helpful for this customer's request. The 3D model is what's best for the customer so if it is available, it is more appreciated.

Regards,

Jonathan