TAS5630: Please confirm the board connectivity for custom PCB, important for power distribution (PBTL)

Maciej Marguz

Part Number: TAS5630
Other Parts Discussed in Thread: DRV135

Hello,

I have creating custom board for TAS5630, size 10x10cm. Most critical are paths for PVDD and OUT_x.

Can you verify attached picture and provide feedback?

As input I will use DRV135 (SE to DIFF)

For an output filter going to use wurth inductors 7uH

0 Shadow He over 2 years ago

Hi Maciej

The PCB seems fine, only some copper seems can be a little wider, depending on how much power you want to play.

0 Maciej Marguz over 2 years ago in reply to Shadow He

Hi Shadow He,

the power I would like to get from this device shall be mas 200W. It going to be drive subwoofer. The signal will be filtered separately.

The supply voltage will be max +45V from linear power supply (torroid).

Thanks for answer, I will make this path wider.

all the best

Audio forum