PCM1808-Q1: Vcc supply timing

Shinji Tsuji

Genius 12338 points

Part Number: PCM1808-Q1
Other Parts Discussed in Thread: PCM1808

Hi team,

Is it OK to apply 5V to Vcc after Vdd powered up?

In my case, There is a case that Vdd applied first and then Vcc applied at the timing below in blue line.

Does the device start up correctly? Is there any concern?

regards,

over 2 years ago

0 Arthur Brown over 2 years ago

TI__Genius 16870 points

Hi,

the PCM1808 doesn't have any power sequencing requirements. the blocks that Vdd and Vcc power are functionally separate form one another.

Regards,
Arthur

0 Shinji Tsuji over 2 years ago in reply to Arthur Brown

TI__Genius 12338 points

Hi Arthur,

Even if Vcc is not applied, the device can receive system clock and then release reset in correct timing?

What kind of function are affected by loss of Vcc?

regards,

0 Arthur Brown over 2 years ago in reply to Shinji Tsuji

TI__Genius 16870 points

Hi Shinji,

I would suspect that yes the reset would release. if Vcc needed to be present for this to happen I suspect is would be included in the timing diagram

But if you don't apply Vcc you wont have any Vref, and then I would expect the ADC to be spitting out garbage data - if it gave any data at all. (because the ADC is referencing the input signal to Vref.

If you where considering not supplying Vcc to the chip I would strongly recommend that you dont do that ;)

Regards,

Arthur

0 Shinji Tsuji over 2 years ago in reply to Arthur Brown

TI__Genius 12338 points

Hi Arthur,

Thank you for the clarification.

I have just concerned the Vcc timing affect the device power on reset timing or not.

I understand Vcc has no impact on device power up. Vcc just required to perform AD conversion.

regards,

Audio

Audio forum

PCM1808-Q1: Vcc supply timing