AICPUREPATH_STUDIO: AGC_MIN_CHANGE Parameter

Eric Smith

Part Number: AICPUREPATH_STUDIO

Hello,

I am setting up an AGC in PurePath Studio. I believe I understand all of the parameters. However, I don't understand how to set the AGC_MIN_CHANGE value as shown in the image. I know what this parameter is, but I don't know how the Value corresponds to the actual dB value.

over 1 year ago

0 Jeff McPherson over 1 year ago

TI__Mastermind 29040 points

Hi Eric,

You should be able to right click the parameter and/or the AGC block and click the "help" button. That will take you to the documentation of the block and there should be a description of how to convert the floating point to a meaningful value.

Best regards,

Jeff

0 Eric Smith over 1 year ago in reply to Jeff McPherson

Prodigy 240 points

Hi Jeff,

I have been looking over the help documentation and see nothing describing how to convert the floating point to a meaningful value.

Thanks,

Eric

0 Jeff McPherson over 1 year ago in reply to Eric Smith

TI__Mastermind 29040 points

Hi Eric,

Ok, in that case can you let us know what device you're trying to build the process flow for?

Thanks,

Jeff

0 Eric Smith over 1 year ago in reply to Jeff McPherson

Prodigy 240 points

I am working on the TLV320AIC3262

+1 pdjuandi over 1 year ago in reply to Eric Smith

TI__Mastermind 29745 points

Hi,

The dB value is just the 20 log of the value i.e. 20 log (0.00625) = -44dB.

Regards.

0 Eric Smith over 1 year ago in reply to pdjuandi

Prodigy 240 points

A -44 dB value does not make sense for the AGC_MIN_CHANGE value. This value applies to the Gain Hysteresis which is usually set to a value around -1 or -2 dB. Is that for sure the right number?

0 pdjuandi over 1 year ago in reply to Eric Smith

TI__Mastermind 29745 points

I believe this is just a number that user will tune/adjust, but the conversion is a direct conversion as with other parameters.

Audio

Audio forum

AICPUREPATH_STUDIO: AGC_MIN_CHANGE Parameter