TAS3308 application information mistake ???

Vladimir Timohin

Other Parts Discussed in Thread: TAS3308, CC2530

Hello, TI!

I was looking TAS3308 datasheet, and found on page 4 (application information) two "VR_ANA2" pins and two "AVSS_PLL"pins. Is it right ?

With best regards, Vladimir.

over 14 years ago

0 dabuan over 14 years ago

TI__Genius 14545 points

Vladimir Timohin said:
Is it right ?

Vladimir,

You are correct. There are two pins that are pined out to allow for the user to add of external capacitors for bulk supply / decoupling. VR_ANA [pin #88], and VR_ANA2 [pin #83]. I have attached the schematic of our evaluation module for your reference.

0 Vladimir Timohin over 14 years ago in reply to dabuan

Prodigy 210 points

Hi, Drew!

Thank you very much for information!

0 chethan kp over 13 years ago in reply to dabuan

Expert 1150 points

Hi,

I'm trying to interface temperature and humidity sensor to cc2530 , This sensor needs bi directional pin and clock pin.

so I planned to use P1_0 as data and P1_1 as clock..

This sensor needs 8MHz on the clock pin so how to genarate this frequency on this channel..?

pls help

Audio

Audio forum

TAS3308 application information mistake ???