PCM1753: What should I do with the pcm1753 register setting?

GeonHee Moon

Part Number: PCM1753
Other Parts Discussed in Thread: PCM1754

I would like to set a register of pcm1753 using spi communication

Is there an example related to this?

0 Paul_Frost over 4 years ago

GeonHee,

The exact conditions depend on what configuration you require in your system. By default, the PCM1753 is configured as shown below:

If you require other configurations, you will need to address those registers.

Thanks,

Paul

0 GeonHee Moon over 4 years ago in reply to Paul_Frost

SPI communication waveform to set register20.

However, the format of PCM1753 does not change.

I need to use a 16bit right-justufued data format.

Can you find a problem?

0 Paul_Frost over 4 years ago in reply to GeonHee Moon

Hi,

That waveform looks correct to me. Can you confirm that the device is correctly powered? What frequency is your SCK, LRCK, and BCK?

Thanks,

Paul

0 GeonHee Moon over 4 years ago in reply to Paul_Frost

Do you need SCK,LRCK,BCK waveforms?

Unfortunately, I2S-related waveforms cannot be measured.

However, when tested using PCM1754 on the same board, the wave file output was smooth.

After changing to PCM1753, it is not outputted.

0 Paul_Frost over 4 years ago in reply to GeonHee Moon

Can you share your schematic?

0 GeonHee Moon over 4 years ago in reply to Paul_Frost

I'm working normally at pcm1754, do you need a schematic?

0 Paul_Frost over 4 years ago in reply to GeonHee Moon

Sharing the schematic will still be useful.

Thanks,

Paul

Audio forum