CDCE6214: how to load into EEPROM and finding I2C

Stephanie Hibler

Part Number: CDCE6214
Other Parts Discussed in Thread: USB2ANY,

Tool/software:

I'm having trouble finding good guidance for loading software into the EEPROM and finding the I2C address using USB2ANY? Software was tested on the EVM so it does work.

Thanks for any help

over 1 year ago

0 Kadeem Samuel over 1 year ago

TI__Mastermind 23280 points

Stephanie,

Are you using the EVM, or a separate board?
Are you using TICS Pro? If so then you should be able to go to USB Communications > Interface and then Scan I2C Bus.

Thanks,
Kadeem

0 Stephanie Hibler over 1 year ago in reply to Kadeem Samuel

TI__Prodigy 725 points

A customer's processor is communicating with a sensor via I2C and then they plug in the UCB2ANY dongle and then the I2C bus crashes

0 Kadeem Samuel over 1 year ago in reply to Stephanie Hibler

TI__Mastermind 23280 points

Stephanie,

To be clear:

Processor is communicating with an I2C sensor on their board
They are attempting to program the CDCE6214 on their board with the USB2ANY
When connecting the USB2ANY, the I2C bus crashes

How are they connecting the USB2ANY? Are they trying to communicate with the sensor while the USB2ANY is trying to communicate with the CDCE6214? Is there any way of disconnecting the processor I2C from the CDCE6214 while connecting the USB2ANY?

Thanks,

Kadeem

Clock & timing

Clock & timing forum

CDCE6214: how to load into EEPROM and finding I2C