Hi
We are using ADS1191 to get ECG signal.We have the similar problem with this thread:
(1) set CH1SET=0x05, CONFIG2=0xE3, get the signal 1Hz 1mV test waveform and that is correct.
(2) but set CH1SET=0x00, CONFIG2=0xE0, The input is from one ECG simulator. there is no ECG wave but only get the noise.
(3) we also try the following thread to change the values of parts and test , but still no obvious wave.
Is there anything else we have to do?
Thanks and regards
Thomas Wang