ADS7044: Regarding ADS control method

t.suzumura

Part Number: ADS7044

Please let me confirm the control method of ADS7044.
When reading SDO, is it necessary to wait some time after setting SCLK to Low level?
In my current environment
If I read SDO about 2μs after setting SCLK to low level, the incorrect value was obtained.
If I read SDO about 40μs after setting SCLK to low level, the correct value was obtained.

I look forward to your reply.

5 months ago

0 Tom Hendrick 5 months ago

TI__Guru**** 168895 points

Hi suzumura-san,

Welcome to our e2e Forum! The only restriction on SDO from the ADS7044 is tSU_CSCK, which is 15nS minimum. Perhaps you can share a screen capture to further explain what you are doing/seeing on your end.

0 t.suzumura 5 months ago in reply to Tom Hendrick

Prodigy 10 points

TIMING REQUIREMENTS are complied with.
Currently tPH_CK = 10μs tPL_CK = 10μs at 50KHz.
In that case, how much delay time is required before reading SDO?

0 Tom Hendrick 5 months ago in reply to t.suzumura

TI__Guru**** 168895 points

Perhaps you can share a screen capture to further explain what you are doing/seeing on your end.

0 t.suzumura 5 months ago in reply to Tom Hendrick

Prodigy 10 points

Is there a minimum value for tD_CKDO?

0 Tom Hendrick 5 months ago in reply to t.suzumura

TI__Guru**** 168895 points

The minimum would be 0, the MAX is expressed in the datasheet as 30-50ns depending on the supply voltage. Perhaps you can share an actual screen capture to further explain what you are doing/seeing on your end.

Data converters

Data converters forum

ADS7044: Regarding ADS control method