TLV2553: Compatibility of TLV2553 and TLV2556

Ryu Yamashita

Part Number: TLV2553
Other Parts Discussed in Thread: TLV2556, ADS7952

Hi team,

I am considering TLV2553 as a replacement for TLV2556.
I am setting data to the internal configuration register (CFGR2) of the TLV2556IPW for external reference mode and EOC mode.
I would like to replace the program as it is.
Is there any inconvenience if I write data to CFGR2, which is reserved in TLV2553?

Sincerely,
Ryu.

8 months ago

+1 Tom Hendrick 8 months ago

TI__Guru**** 172816 points

Hi Ryu,

In the end, does it make a difference? Both the TLV2553 and TLV2556 have been set to 'EOL' status. The recommended replacement device is the ADS7952 which will require a different footprint and software interface from either of the TLC25xx devices.

0 Ryu Yamashita 8 months ago in reply to Tom Hendrick

Expert 2240 points

Hi Tom,

I was going to use my on-board products as they are still available for purchase.

+1 Tom Hendrick 8 months ago in reply to Ryu Yamashita

TI__Guru**** 172816 points

Command 'F' in the TLV2553 is reserved. It would be prudent to remove that portion of the code from the initialization sequence.

0 Ryu Yamashita 8 months ago in reply to Tom Hendrick

Expert 2240 points

Hi Tom,

Does this mean that writing to a reserved register may cause unstable behavior?

+1 Tom Hendrick 8 months ago in reply to Ryu Yamashita

TI__Guru**** 172816 points

Yes - that is a possibility.

Data converters

Data converters forum

TLV2553: Compatibility of TLV2553 and TLV2556