TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS1292R: Usage of Bipolar supply 0 Locked

    289 views
    1 reply
    Latest over 6 years ago
    by Ryan Andrews
  • Answered

    ADS8568: Configuration register doesn't read-out and AD code out by a factor of two 0 Locked

    1063 views
    3 replies
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    DAC3482: configuration of DAC3482's register 0 Locked

    574 views
    1 reply
    Latest over 6 years ago
    by Kang Hsia
  • Suggested Answer

    ADS1255: incorrect output code (FFFFFC) output 0 Locked

    410 views
    4 replies
    Latest over 6 years ago
    by Tom Hendrick
  • Answered

    ADS7042: Maximum analog input current of ADS7042 0 Locked

    272 views
    2 replies
    Latest over 6 years ago
    by yoshiki hasebe
  • Answered

    ADS1262: REFOUT voltage when using Bipolar supply 0 Locked

    308 views
    2 replies
    Latest over 6 years ago
    by NAOKI AOYAMA
  • Suggested Answer

    AFE5808: AFE5808 0 Locked

    1033 views
    4 replies
    Latest over 6 years ago
    by Chen Kung
  • Suggested Answer

    ADS1247: RESET pin function 0 Locked

    412 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Answered

    ADS1220: SPI Timeout datasheet clarification 0 Locked

    359 views
    1 reply
    Latest over 6 years ago
    by Bob Benjamin
  • Suggested Answer

    CCS/ADS1675: FPGA CODE 0 Locked

    608 views
    1 reply
    Latest over 6 years ago
    by Keith Nicholas
  • Suggested Answer

    LMP92066: LMP92066 device version A1 output voltage accuracy 0 Locked

    595 views
    10 replies
    Latest over 6 years ago
    by Paul_Frost
  • Suggested Answer

    ADS1298 Decoupling/Bypassing 0 Locked

    1502 views
    3 replies
    Latest over 6 years ago
    by Alexander Smith
  • Suggested Answer

    AFE4490: Calculate SpO2 values using AFE4490 0 Locked

    608 views
    2 replies
    Latest over 6 years ago
    by Sayan Seth
  • Suggested Answer

    ADS1256: ADS1256 0 Locked

    7145 views
    4 replies
    Latest over 6 years ago
    by Christopher Hall
  • Suggested Answer

    TLV2553: Output pins not going low 0 Locked

    980 views
    6 replies
    Latest over 6 years ago
    by Alexander Smith
  • Answered

    ADS8363EVM: ADC evm software control 0 Locked

    501 views
    1 reply
    Latest over 6 years ago
    by Ryan Andrews
  • Suggested Answer

    ADS41B25EVM: Breakout board 0 Locked

    341 views
    1 reply
    Latest over 6 years ago
    by RJ Hopper
  • Answered

    AFE4490: Capabilities 0 Locked

    338 views
    4 replies
    Latest over 6 years ago
    by Werner Vorster
  • Suggested Answer

    AFE4300: Clarifications about implementing bio-impedance measurements 0 Locked

    516 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
  • Suggested Answer

    AFE4300: Clarifications about implementing bio-impedance measurements 0 Locked

    331 views
    1 reply
    Latest over 6 years ago
    by Prabin Yadav
<>