TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    ADS8638: 91Hz Spurious in ADS8638 0 Locked

    997 views
    3 replies
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    ADS7953EVM-PDK: Sample embedded C code to setup and communicate with the ADS7953EVM over SPI 0 Locked

    1827 views
    1 reply
    Latest over 6 years ago
    by Cynthia
  • Suggested Answer

    TINA/Spice/ADS7039-Q1: ADS7039-Q1 spice model 0 Locked

    458 views
    1 reply
    Latest over 6 years ago
    by Art Kay
  • Answered

    ADS1115: what is the FSR of the ADS1115 0 Locked

    3331 views
    3 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    DAC121S101QML-SP: dac121s101qml-sp case/lid connection 0 Locked

    321 views
    1 reply
    Latest over 6 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    ADC128S102QML-SP: adc128s102qml-sp case/lid connection 0 Locked

    388 views
    1 reply
    Latest over 6 years ago
    by Kirby Kruckmeyer96848
  • Suggested Answer

    DAC8830: DAC8830 Reference Input Current 0 Locked

    670 views
    2 replies
    Latest over 6 years ago
    by Kevin Duke
  • Suggested Answer

    TLC2543: TLC2543 Errors (INL, DNL, Offset, Gain, Total) 0 Locked

    628 views
    1 reply
    Latest over 6 years ago
    by Art Kay
  • Answered

    Compiler/ADS8513: Regarding ads 7952 Mode control register address 0 Locked

    457 views
    1 reply
    Latest over 6 years ago
    by Dale Li
  • Suggested Answer

    ADS8681EVM-PDK: No graph on Time Domain Display after "Capture" 0 Locked

    579 views
    4 replies
    Latest over 6 years ago
    by Dale Li
  • Not Answered

    TSW1400EVM: How to directly read the data in TSW1400 DDR with Matlab? 0 Locked

    509 views
    1 reply
    Latest over 6 years ago
    by Yusuf%20Agoro
  • Not Answered

    JESD204B over fiber 0 Locked

    456 views
    3 replies
    Latest over 6 years ago
    by Xiongmao xiao
  • Suggested Answer

    ADS131A04EVM: Data Analysis no working 0 Locked

    290 views
    2 replies
    Latest over 6 years ago
    by NicoPierre
  • Answered

    ADS1248: I would like to ask you to check the circuit of my customer. 0 Locked

    609 views
    5 replies
    Latest over 6 years ago
    by Takumi Suzuki1
  • Suggested Answer

    ADS1292R: Can you recommend register setting? 0 Locked

    681 views
    5 replies
    Latest over 6 years ago
    by Seonjo Lim
  • Answered

    DAC121S101QML-SP: DAC121S101QML SEU Report 0 Locked

    732 views
    2 replies
    Latest over 6 years ago
    by David Thorndike
  • Answered

    ADC12D1620QML-SP: Error in data sheet regarding SDR/DPS bits in ECM registers 0 Locked

    384 views
    2 replies
    Latest over 6 years ago
    by Jim Brinkhurst1
  • Suggested Answer

    ADS1118: Interrupt too soon, noisy, shifted levels 0 Locked

    488 views
    2 replies
    Latest over 6 years ago
    by Joseph Wu
  • Suggested Answer

    ADS1248: Configuration for external Vref and unipolar inputs 0 Locked

    595 views
    3 replies
    Latest over 6 years ago
    by Joseph Wu
  • Answered

    TSC2046: ESD trouble 0 Locked

    870 views
    4 replies
    Latest over 6 years ago
    by Collin Wells
<>