TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    ADS8588S: ADS8588S PGA chang the gain 0 Locked

    471 views
    1 reply
    Latest over 7 years ago
    by Dale Li
  • Suggested Answer

    ADS1204: with bridge sensors 0 Locked

    824 views
    3 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Suggested Answer

    ADS1291: Device ID Issue 0 Locked

    525 views
    1 reply
    Latest over 7 years ago
    by Alexander Smith
  • Suggested Answer

    DAC8760: Behaviour of current output at SPI error 0 Locked

    250 views
    1 reply
    Latest over 7 years ago
    by Garrett Satterfield
  • Answered

    TSW1400EVM: labview file not found error 0 Locked

    970 views
    5 replies
    Latest over 7 years ago
    by gibbeum lee
  • Suggested Answer

    AMC1304L25: gain error when sensing voltage : front end question 0 Locked

    908 views
    8 replies
    Latest over 7 years ago
    by Tom Hendrick
  • Answered

    ADS4249: ADS4249EVM + FMC-ADC-Adapter 0 Locked

    644 views
    1 reply
    Latest over 7 years ago
    by dBrock
  • Answered

    ADS5463: Suggestion on FPGA board to work with ADS5463 and DAC3152 0 Locked

    2160 views
    10 replies
    Latest over 7 years ago
    by vinitk99
  • Suggested Answer

    TSW1400EVM: when I push the PostProc button, the picture plotted doesn't show the things which are moving,why? 0 Locked

    624 views
    4 replies
    Latest over 7 years ago
    by Anand Gadiyar
  • Suggested Answer

    AFE4300: Roadmap for AFE4300 0 Locked

    355 views
    1 reply
    Latest over 7 years ago
    by Prabin Yadav
  • Suggested Answer

    ADS8902B: LDO output voltage issue 0 Locked

    2451 views
    17 replies
    Latest over 7 years ago
    by Jeffrey
  • Suggested Answer

    ADS1220: How to use to +/-%V analog signal? 0 Locked

    532 views
    2 replies
    Latest over 7 years ago
    by Sridhar M S
  • Answered

    Suitable low-power multi- channel ADC for bridge sensors (strain gauges). 0 Locked

    1026 views
    3 replies
    Latest over 7 years ago
    by Bob Benjamin
  • Suggested Answer

    DAC60096: Assembly inquiry (first-timer) 0 Locked

    345 views
    1 reply
    Latest over 7 years ago
    by Paul_Frost
  • Answered

    TSW1400EVM: I can't find the xwr12xx_masterss.bin file in the dfp to load the TSW1400,could you help me ?Thank you very much 0 Locked

    463 views
    2 replies
    Latest over 7 years ago
    by user5776592
  • Answered

    ADS8885: What are these input driver symbols 0 Locked

    2357 views
    15 replies
    Latest over 7 years ago
    by Sam Pattemore
  • Suggested Answer

    DAC8742H: DAC8742HPBS 0 Locked

    483 views
    1 reply
    Latest over 7 years ago
    by Garrett Satterfield
  • Suggested Answer

    Compiler/FDC2214EVM: Unable to build the firmware source installed with GUI module 0 Locked

    898 views
    7 replies
    Latest over 7 years ago
    by Kristin Jones93
  • Answered

    ADC32RF45EVM: Setting up ADC32RF45EVM using the documentation 0 Locked

    1966 views
    18 replies
    Latest over 7 years ago
    by Aravind Venkitasubramony
  • Answered

    ADS54J40: JESD IP core License 0 Locked

    1254 views
    7 replies
    Latest over 7 years ago
    by jim s
<>