TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    IMX6 TVP5151 error 0 Locked

    2937 views
    4 replies
    Latest over 9 years ago
    by Nick 199
  • Not Answered

    DAC39J84 EVM 0 Locked

    380 views
    1 reply
    Latest over 9 years ago
    by Mark Elkin
  • Not Answered

    TVP5150 video decoder 0 Locked

    2103 views
    3 replies
    Latest over 9 years ago
    by Steve Clynes
  • Answered

    ADS1120 with earthed thermocouples 0 Locked

    500 views
    2 replies
    Latest over 9 years ago
    by Stephen Hughes97
  • Answered

    ADS8860: Multiple channel ADC conversion with single voltage reference 0 Locked

    566 views
    1 reply
    Latest over 9 years ago
    by Luis Chioye
  • Not Answered

    AFE4300 I/Q Question 0 Locked

    693 views
    2 replies
    Latest over 9 years ago
    by Steve Hayes72
  • Suggested Answer

    ADS 1299 and LabVIEW 0 Locked

    1549 views
    5 replies
    Latest over 9 years ago
    by Leonardo Silva3
  • Not Answered

    ADS54J54EVM FMC Connection 0 Locked

    4047 views
    6 replies
    Latest over 9 years ago
    by David Li16
  • Not Answered

    ADS1299 RDATAC mode setup problem. 0 Locked

    1165 views
    4 replies
    Latest over 9 years ago
    by Jerry Liu0
  • Suggested Answer

    ADS1120-Q1 questions 0 Locked

    346 views
    2 replies
    Latest over 9 years ago
    by Bob Benjamin
  • Suggested Answer

    help me i need a code for stm32 and ads1018 0 Locked

    509 views
    1 reply
    Latest over 9 years ago
    by Bob Benjamin
  • Answered

    ADS1120 input impedance 0 Locked

    286 views
    1 reply
    Latest over 9 years ago
    by Christopher Hall
  • Answered

    noise found during thermistor measurement on ADS1220EVM using ADCPro 0 Locked

    709 views
    1 reply
    Latest over 9 years ago
    by Bob Benjamin
  • Answered

    ADS7850 data output before Conversion finished 0 Locked

    399 views
    1 reply
    Latest over 9 years ago
    by Dale Li
  • Answered

    ADS4249EVM can not connected by USB, and High Speed Data Converter Pro Software shows strange code form. 0 Locked

    433 views
    4 replies
    Latest over 9 years ago
    by Dewen Duan
  • Answered

    Interface OMAP L138 LCDK with ADS1602 EVM using 5-6k interface platform 0 Locked

    1437 views
    3 replies
    Latest over 9 years ago
    by Tom Hendrick
  • Answered

    DAC121C085 - I2C Addresses 0 Locked

    1117 views
    2 replies
    Latest over 9 years ago
    by Ken Henderson
  • Answered

    ADS8861EVM Lab View Code 0 Locked

    392 views
    2 replies
    Latest over 9 years ago
    by Jim Denison
  • Suggested Answer

    Some sensor output unexpected value by afe4400 0 Locked

    923 views
    4 replies
    Latest over 9 years ago
    by Cheyne Gaw Ho
  • Answered

    ADS1248 internal reference 0 Locked

    1151 views
    9 replies
    Latest over 9 years ago
    by Felix Weilenmann
<>