TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1241 Crystal driver specification 0 Locked

    1303 views
    6 replies
    Latest over 9 years ago
    by Joseph Wu
  • Answered

    Can I get a FPGA source code for ads8568? 0 Locked

    357 views
    2 replies
    Latest over 9 years ago
    by remzi inan
  • Answered

    Ads1262 with arduino for 2 wire rtd 0 Locked

    1958 views
    1 reply
    Latest over 9 years ago
    by Christopher Hall
  • Not Answered

    Regarding maximum duty ratio of PWM IC UC1824 or UC1524 0 Locked

    384 views
    0 replies
    Started over 9 years ago
    by TI_Electronics
  • Suggested Answer

    ADS1015 - how to read samples as fast as possible on I2C 0 Locked

    1343 views
    1 reply
    Latest over 9 years ago
    by Krunal Maniar
  • Answered

    comprehension question: Sampling-Rate vs. Settlingtime 0 Locked

    416 views
    3 replies
    Latest over 9 years ago
    by Brian Pisani
  • Suggested Answer

    electrode compatibility with ADS1298 0 Locked

    519 views
    4 replies
    Latest over 9 years ago
    by Noel Teku
  • Answered

    DAC8750: mutli-channel design with several IC's sharing the same Analog & digital power-supplies 0 Locked

    269 views
    1 reply
    Latest over 9 years ago
    by Eugenio Mejia
  • Suggested Answer

    ads1298 ¿where is the circuit of the electrocardiogram? 0 Locked

    281 views
    2 replies
    Latest over 9 years ago
    by Harsh garg
  • Not Answered

    ADC34j42evm 0 Locked

    536 views
    3 replies
    Latest over 9 years ago
    by Ken C
  • Suggested Answer

    DAC37J84 reference design and interface question 0 Locked

    468 views
    1 reply
    Latest over 9 years ago
    by Kang Hsia
  • Answered

    ADC12J2700 latency 0 Locked

    310 views
    1 reply
    Latest over 9 years ago
    by Jim Brinkhurst1
  • Answered

    Regarding electorde connection with ADS1298 0 Locked

    288 views
    5 replies
    Latest over 9 years ago
    by Brian Pisani
  • Answered

    Raspberry Pi Interface with ADS 1299 0 Locked

    1969 views
    1 reply
    Latest over 9 years ago
    by Brian Pisani
  • Not Answered

    DP83848I/ withstand voltage on MDI Terminals 0 Locked

    448 views
    1 reply
    Latest over 9 years ago
    by Orobianco-Italy
  • Not Answered

    UC1844J 0 Locked

    763 views
    2 replies
    Latest over 9 years ago
    by Rabotinskiy Egeniy
  • Answered

    the SPI interface between ADS1298 and MSP430F5529 0 Locked

    438 views
    3 replies
    Latest over 9 years ago
    by Harsh garg
  • Answered

    ADS1248 External voltage reference & no. of input channel 0 Locked

    1412 views
    7 replies
    Latest over 9 years ago
    by Chandrashekhar Rane
  • Answered

    ADS1248 0 Locked

    449 views
    4 replies
    Latest over 9 years ago
    by Prashant Mulay
  • Answered

    Use external clock with ADC12J4000 0 Locked

    694 views
    10 replies
    Latest over 9 years ago
    by Michael Robertson52
<>