TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    ADS1198 Right Arm lead-off status only when LOFF_FLIP = 0x00. 0 Locked

    917 views
    3 replies
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    sm28vlt32-ht Endurance 0 Locked

    249 views
    1 reply
    Latest over 10 years ago
    by Amy Schnoor
  • Not Answered

    opportunity of ADC 0 Locked

    323 views
    1 reply
    Latest over 10 years ago
    by RJ Hopper
  • Answered

    ADS8422 incorrect data at particular voltage range 0 Locked

    596 views
    4 replies
    Latest over 10 years ago
    by Shridhar%20More
  • Answered

    DAC8728 has strange behavior while converting 0 Locked

    2403 views
    18 replies
    Latest over 10 years ago
    by ser str
  • Answered

    ADS1115 characteristics 0 Locked

    684 views
    7 replies
    Latest over 10 years ago
    by NAOKI AOYAMA
  • Answered

    Disable MSP430F5529 on ADS1293 0 Locked

    481 views
    1 reply
    Latest over 10 years ago
    by Vishy Viswanathan
  • Not Answered

    Initializing and reading a AFE4490 using a MSP430F5659 0 Locked

    733 views
    3 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Answered

    How to choose a photodiode and led for AFE4400 not a commercial one 0 Locked

    611 views
    3 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Answered

    ADS1014 - Write to CONFIG register seems to succeed, but read fails with NAK 0 Locked

    1350 views
    8 replies
    Latest over 10 years ago
    by Dave Matsumoto
  • Answered

    TIDA-00009 ref design 0 Locked

    1039 views
    10 replies
    Latest over 10 years ago
    by Amy Schnoor
  • Not Answered

    AFE5851 SPI - Using Pattern Data as a Frame Clock 0 Locked

    370 views
    2 replies
    Latest over 10 years ago
    by Chuck Smyth
  • Not Answered

    ADS5527 Clock input inpedance 0 Locked

    349 views
    1 reply
    Latest over 10 years ago
    by Matt Guibord
  • Suggested Answer

    ADS8556 HW mode 0 Locked

    669 views
    5 replies
    Latest over 10 years ago
    by Tom Hendrick
  • Answered

    ADS1299 Electrode Design (on Figure 59) 0 Locked

    570 views
    3 replies
    Latest over 10 years ago
    by Brian Pisani
  • Suggested Answer

    ADS1298 and Arduino Uno / DRDY Abnormal Output(?) 0 Locked

    2552 views
    1 reply
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    ADS1192 - power consumption in case of using internal clock or external clock 0 Locked

    374 views
    4 replies
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    DAC5682Z driven by Xilinx Artix 7 AC701 evaluation board 0 Locked

    1126 views
    3 replies
    Latest over 10 years ago
    by jim s
  • Answered

    ADS130E08 - unused input pins and ch skip 0 Locked

    386 views
    3 replies
    Latest over 10 years ago
    by Hirotaka Matsumoto
  • Discussion

    ADS 1675 Example project Locked

    367 views
    1 reply
    Latest over 10 years ago
    by Greg Hupp
<>