TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Data converters

Data converters

Data converters forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Data converters support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search data converter IC content or ask technical support questions on everything from analog to digital converters (ADCs) and digital to analog converters (DACs) to high speed ADCs and special function data converters. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AFE5816: AFE58xx and ADS52xx: Details about LVDS bit and Frame clock of ADS52xx and AFE58xx devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5816 The LVDS bit clock and the frame clock scales down based on the decimation factor. The LVDS bit clock frequency (LCLK) is dependent on the sample rate and the type of wire interface (1-wire or 2-wire). And the sample rate is factor…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD16: True digital TGC devices (e.g. AFE58JD16) with accurate timing of when channel gains are changed vs SPI-controlled TGC devices.

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD16 Digital control of TGC via SPI intended for fixed attenuation/testing. Analog control TGC is piecewise linear but it is possible to specify the timing of uniform and non-uniform time gain control using programmed settings on our…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] TX517EVM: Provide details about the TX517 EVM power supplies and their functions.

    Praveen Aroul
    Praveen Aroul
    Part Number: TX517EVM The TX517 EVM requires all 11 power supplies and their functions are listed in the datasheet pin description section. https://e2e.ti.com/support/applications/medical/f/30/t/535845
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5801: Should we buy the interposer card to connect to AFE5801EVM to TSW1400 board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5801 The AFE5801 EVM ships with the adapter card for the TSW1400EVM . It does not need to be ordered separately. https://e2e.ti.com/support/applications/medical/f/30/t/503459 https://e2e.ti.com/support/applications/medical/f/30/t/…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE58JD18: AFE58JDxx: What should we do with unused JESD CML outputs pin, CLK_1X, CLK_16X input pins?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE58JD18 Unused JESD CML pins, CLK_1X, CLK_16X, NC pins can be left floating. http://e2e.ti.com/support/applications/medical/f/30/t/550784 http://e2e.ti.com/support/applications/medical/f/30/t/547048
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] ADS52J90: How to terminate SYNC_SERDES, SYSREF_SERDES signals in ADS52J90?

    Praveen Aroul
    Praveen Aroul
    Part Number: ADS52J90 SYNC and SYSREF pins’ termination were recently updated to the architecture below in order reduce glitches and false triggers. https://e2e.ti.com/support/applications/medical/f/30/t/585265
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to load the saved settings at startup in AFE5809? Will the profile ram hold the configuration values after power off?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 User-defined device settings cannot be used to configure the AFE5809 at startup but specific configuration steps can be saved in a CMD file by using the GUI’s “record command” and “save command” features. http://e2e.ti.com/support…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5809: How to access the coefficient memory for the filter coefficient in AFE5809?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5809 For Coefficient memory accesses, the SPI write is different than a standard SPI write of 24 bits. It will be a single SPI cycle access of 120 bits (8 bits of address followed by 112 bits of data with MSB first) The SEN signal should…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: Provide details about the Adapters from HSMC (Altera) and FMC (Xilinx) to interface to TI serial LVDS connectors

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM The following TI adapters can be used with our serial LVDS AFExx and ADSxxxx devices to interface with Altera and Xilinx FPGA boards. http://www.ti.com/tool/HSMC-ADC-BRIDGE?keyMatch=hsmc-adc-bridge&tisearch=Search-EN-Everything…
    • over 7 years ago
    • Data converters
    • Data converters forum
  • [FAQ] AFE5818EVM: What are the recommended guidelines to use the ADS529xEVM, AFE58xxEVM with any FPGA board?

    Praveen Aroul
    Praveen Aroul
    Part Number: AFE5818EVM Refer to the posts below for guidelines to use AFE58xxEVM and ADS529xEVM with any FPGA board. http://www.ti.com/tool/TIDA-00069 https://e2e.ti.com/support/applications/medical/f/30/t/433667 https://e2e.ti.com/support/applications…
    • over 7 years ago
    • Data converters
    • Data converters forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    TLV5618A output current source/sink 0 Locked

    555 views
    1 reply
    Latest over 10 years ago
    by Eugenio Mejia
  • Suggested Answer

    TSW1400 doesn't work with DAC5682zEVM 0 Locked

    568 views
    4 replies
    Latest over 10 years ago
    by Neeraj Gill
  • Answered

    ADS1120 input filtering questions - Thermistors bridge 0 Locked

    870 views
    3 replies
    Latest over 10 years ago
    by Bob Benjamin
  • Not Answered

    EVM that I can use as LO source from up to 3GHz? 0 Locked

    283 views
    2 replies
    Latest over 10 years ago
    by Ruikang Yang
  • Not Answered

    Why do I need to run SYSREF continuously with DAC38j84? 0 Locked

    1470 views
    5 replies
    Latest over 10 years ago
    by Matt Guibord
  • Answered

    What is the output frequency of ORI and ORQ outputs in demux mode ADC12dXXXX? 0 Locked

    889 views
    8 replies
    Latest over 10 years ago
    by Ilya Grudovik
  • Discussion

    AFE5805EVM + TSW1250 Locked

    2991 views
    17 replies
    Latest over 10 years ago
    by chao zhu
  • Not Answered

    AFE5805 noise 0 Locked

    874 views
    7 replies
    Latest over 10 years ago
    by chao zhu
  • Answered

    About ADC12D1X00RFRB 0 Locked

    481 views
    1 reply
    Latest over 10 years ago
    by Luke LaPointe
  • Suggested Answer

    ADS1298ECGFE-PDK with Windows 7 0 Locked

    1813 views
    12 replies
    Latest over 10 years ago
    by Brian Pisani
  • Not Answered

    Why TVP5146 output signal fading away 0 Locked

    586 views
    1 reply
    Latest over 10 years ago
    by Steve Clynes
  • Answered

    ADC16dx370 Power Supply Design 0 Locked

    426 views
    1 reply
    Latest over 10 years ago
    by Joshua Carnes
  • Answered

    ADS8684 Unused pin 0 Locked

    483 views
    1 reply
    Latest over 10 years ago
    by Luis Chioye
  • Answered

    ADC16DX370 unused channel 0 Locked

    1547 views
    4 replies
    Latest over 10 years ago
    by Berlauber
  • Answered

    Inquiry regarding I2C CLK period on ADS7828 0 Locked

    445 views
    1 reply
    Latest over 10 years ago
    by Luis Chioye
  • Answered

    ADS1241 (do I need clean supply or just Vref) 0 Locked

    685 views
    1 reply
    Latest over 10 years ago
    by Joseph Wu
  • Answered

    ads7843 driver 0 Locked

    1588 views
    4 replies
    Latest over 10 years ago
    by Andy Liu (BMS)
  • Suggested Answer

    ads1292 Safety verification of medical 0 Locked

    357 views
    1 reply
    Latest over 10 years ago
    by Brian Pisani
  • Answered

    ADS1292R EVM use for respiration 0 Locked

    439 views
    1 reply
    Latest over 10 years ago
    by Brian Pisani
  • Not Answered

    How to properly clock ADS4249EVM from FPGA 0 Locked

    1333 views
    1 reply
    Latest over 10 years ago
    by Matt Guibord
<>