DLP4710EVM-LC: trouble

Nobukazu Yoshikawa

Part Number: DLP4710EVM-LC

I have recently purchased a DLP4710EVM-LC. I followed the Quick-Start Procedure in the manual to start the DLP4710EVM-LC.

When I pushed the SW21, the power was turned on and a splash image was projected. I was also able to change the image using the GUI of the software installed on my PC. After that, I followed the Quick-Start Procedure and shut down the DLP4710EVM-LC.

Then, I started the DLP4710EVM-LC in the same way. The power was turned on. However, the light did not turn on when I pressed SW21. I could not see any image.

Please tell me how to start the projector.

The firmware has not been changed.

over 2 years ago

0 Philippe Dollo over 2 years ago

TI__Mastermind 28005 points

Yoshikawa-san,

Welcome to the E2E forums and thanks for your interest in our DLP technology.

Have you tried reprogramming the board with the original DLP4710-LC EVM firmware? You should still be able to perform flash update function even if the board is not coming up. (Download at https://www.ti.com/tool/DLP4710EVM-LC)

What did you change about the flash image when the board failed? There may have been something wrong with your selected image.

Regards,

Philippe Dollo

0 Nobukazu Yoshikawa over 2 years ago

Prodigy 10 points

Hi Philippe,

I thank you so much for your reply.

I would like to try the flash update function using DLP4710-LC EVM firmware.

I found the firmware you suggested.

"DLP4710EVM-LC-FW – DLP4710EVM LightCrafter Firmware, Version: v8.1.0, Release date: 18-Jun-2020".

This is it, right?

I have not updated or rewritten the firmware on my projector yet. It is still in its initial state.

I have selected the four images and the monochromatic color imges presented in the software. These were presented on the left side and right side of one screen.

Regards,

Nobukazu Yoshikawa

0 Arthur Brown over 2 years ago in reply to Nobukazu Yoshikawa

TI__Genius 17250 points

Hello Yoshikawa-san,

Correct, this is the most recent version of the firmware.

Regards,
Arthur Brown

0 Philippe Dollo over 2 years ago in reply to Arthur Brown

TI__Mastermind 28005 points

Yoshikawa-san,

That should be OK. Let me know what result you get.

Regards,

Philippe

+1 Nobukazu Yoshikawa over 2 years ago in reply to Philippe Dollo

Prodigy 10 points

Hi Philippe,

I was able to update the firmware successfully.
Thank you very much for your help.

Best regards.

Nobukazu Yoshikawa

DLP®︎ products

DLP products forum

DLP4710EVM-LC: trouble