• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 32 subscribers
  • Views 148 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS90LV001: measuring VOS for functional test

Ue
Genius 16285 points
Part Number: DS90LV001

Hi all

Please find a question from my customer copied below.

Can you review and comment ?

Best regards

Ueli

------------------------------------

I need some help from TI regarding the test setup to measure VOS for this part.

Can I setup the buffer in this way shown below for measuring the VOS?

I just need to do a quick measurement to test if the connection/soldering of the chip is good during functional test.

  • +1
    TI__Expert 7610 points

    Hello Ueli,

    Looking at the datasheet, this device has a recommend receiver input voltage of 0V to Vcc. However, care should be taken not to surpass the max differential voltage of the device. I would not recommend having such a large voltage swing between IN+ and IN-. 

    Having IN+ equal to 1.375V (~1.4V) and IN- equal to 1.025 (~1V) should be fine. This makes sure the max differential voltage is not reached and it satisfies the high/low differential threshold of +/- 100mV.

    Regards,

    Josh 

  • 0 in reply to Joshua Salinas
    TI__Genius 16285 points

    Hello Josh

    Thank you for the quick reply !

    Best regards

    Ueli