Hi TI
We are using the TS3USBCA420 on the board & connected the AUX signals from SoC to the Type-C connector through the TS3USBCA420 as shown in the pic.
When we have bypassed [unstuffed] the TS3USBCA420 on the board & directly connected the AUX signals from SoC to the Type-C connector. Able to see the display content over the Type-C port.
Now strongly suspecting the TS3USBCA420 was unable configure to map the AUX signals of LNA to the SBU using the PD bin image hence display was not working fine.
Could you help us and let us know let us know the necessary settings are needed to enable the Display in the below mentioned PD tool snippet:
