TPD2S703-Q1: TPD2S703-Q1

Tony Nohra

Part Number: TPD2S703-Q1

Hello E2E Team,

Can you check this Sch. for the TPD2S703-Q1, mode 1, always protected Short-to-Battery Setup.

Thank you,

Tony

+1 Kuno Wu over 2 years ago

Hi Tony,

Thank you for reaching out us, below are my comments about the schematic review.

1, The /FLT pin is a open-drain output pin, so we need to pull up it to 5V.

2, For the CMC and inductor, you can use the mcf12102g900 and LQG15HS10NJ02D.

Others are ok to me.

Best Regards,

Kuno

0 Tony Nohra over 2 years ago in reply to Kuno Wu

Hi Kuno,

Thank you, for the CMC I'll be using the ACM-21-900M-T.

For pin /FLT, I'll add a pull-up to 3.3V the MCU I/O VDD.

Thanks,

Tony

0 Kuno Wu over 2 years ago in reply to Tony Nohra

Hi Tony,

Ok, if you have any question in the future, feel free to submit a thread in the E2E, thank you.

Best Regards,

Kuno

Interface forum