Original question:
DP83TC811S-Q1: How to connect ethernet pins to unidirectional connector (100Mbit)
Hi,
In the previous post there is a solution suggested for a unidirectional to bidirectional converter solution. From 100BASE-T1 to Ethernet 100Base-TX, using DP83822 as an intermediate.
Could you give support on how the connection would look like? I used the reference design from the EVM https://www.ti.com/tool/DP83TC811EVM
Thank you!
Best,
Cora
Hello Cora,
For the connection instead of connecting it as shown in the picture attached, you have to use the MII lines based on which configuration you want to be in MII, RMII, or RGMII.
Regards,
Avtar
