• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 88 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TCA8418: Schematic Review

Ryu Yamashita
Expert 2030 points
Part Number: TCA8418

Hi team,

I am trying to implement this device with the attached circuit using an external pull-up.
The internal pull-up will be turned off with a register.
Is there any problem?

Also, am I correct in thinking that in keyscan mode, internally col is working as an output pin and row as an input pin?

Sincerely,
Ryu.

  • 0
    TI__Mastermind 27173 points

    Hi Ryu,

    No problem in turning off the internal pull-up resistors. External pull-ups here will work just fine, however, I think internal pull-ups will be needed on the ROW pins set to input. When the COL outputs a LOW signal and a button is de-pressed, the ROW pin will receive a logic LOW, however when the button is released, there is no way for the ROW input pin to rise to a logic HIGH voltage unless a pull-up is present on the pin internally or externally. 

    Ryu Yamashita said:
    Also, am I correct in thinking that in keyscan mode, internally col is working as an output pin and row as an input pin?

    yes I believe this is correct. 

    Regards,

    Tyler