Other Parts Discussed in Thread: UCD9081
Tool/software:
Hi,
I try to read the UCD9081 Device ID of 0x55 from register 0x27, but it reports 0x00. I use a custom USBC to I2C bridge board for this purpose.
Br,
Mozhdeh
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Tool/software:
Hi,
I try to read the UCD9081 Device ID of 0x55 from register 0x27, but it reports 0x00. I use a custom USBC to I2C bridge board for this purpose.
Br,
Mozhdeh
Hi
I would recommend to use TI's USB-TO-GPIO V2 dongle(https://www.ti.com/tool/USB-TO-GPIO2) to test to ensure that your design is good first.
Your host need support clock stretching and speed need be not over 100KHz.
Regards
Yihe
Hi, is there any TI device that does not need clock stretching? Our host does not support that!
Hi
You may change your host's software to support. UCD9081 need clock stretching.
Regards
Yihe
Our host is FT2232 which does not support clock stretching! So we want to use an other power sequencer which does not require that.
Bests,
Mozhdeh
Hi
All our sequencers require clock stretching. Have your checked the software team or chip vendor of FT2232 for capability of clock stretching?
Regards
Yihe