• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 33 subscribers
  • Views 164 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

SN65DSI83: Considerable sequence when MIPI source and I2C master is different

Hideki Hayashi1
Expert 8420 points
Part Number: SN65DSI83

Tool/software:

Hi team,

Customer will use different processor for MIPI source and I2C master.

Is there any care about for this case such as sequence?

I found EN pin and I2C writing must follow below. Please let me know other considerable sequence

Best regards,

Hayashi

  • 0
    TI__Guru**** 178126 points

    Hayashi-san

    Please make sure to follow the power up sequence as outlined in above section. 

    There is an internal pullup resistor on the DSI83 EN pin, so you would only need an external capacitor for a passive reset circuit as shown below for step 3 and 4.

    Thanks

    David