TPS2513A-Q1: Does TI has Dedicated Charger controller IC, that will support BC 1.2, Apple 2.1A and 2.4A?

Sergii Makovetskyi UA

Prodigy 80 points

Part Number: TPS2513A-Q1
Other Parts Discussed in Thread: TPS2513A, TPS2549, TUSB321

Dear support team,

could you please tell me, does TI has Dedicated Charger controller IC, that will support BC 1.2, Apple 2.1A and 2.4A?

I am going to make USB-C charge station and can't find any ICs at your site, that supports both standards.

I found that you have TPS2513 and TPS2513A. But one support only 5W and 10W, and another only 12W. Please help

Best regards, Sergii

over 7 years ago

0 Eric Wright over 7 years ago

TI__Mastermind 42795 points

TPS2513A/14A can support these devices. Our test data shows that divider 2 (10W) devices also charge when presented with divider 3 (12W) on D+/D-

0 Sergii Makovetskyi UA over 7 years ago in reply to Eric Wright

Prodigy 80 points

Thank you for your answer. What about TPS2549? Will it charge at 10W too? I found this IC very interesting, because it has cable loss compensation.

0 Eric Wright over 7 years ago in reply to Sergii Makovetskyi UA

TI__Mastermind 42795 points

Yes. TPS2549 DCP_Auto mode is similar to TPS2513A in that it defaults to divider 3, then BC1.2, then 1.2V mode. TPS2549 also supports CDP 1.5A charging for applications requiring USB data pass through.

0 Sergii Makovetskyi UA over 7 years ago in reply to Eric Wright

Prodigy 80 points

Ok, Thanks a lot for the support! I will use TPS2549 with TUSB321 for USB-C charger than.

Interface

Interface forum

TPS2513A-Q1: Does TI has Dedicated Charger controller IC, that will support BC 1.2, Apple 2.1A and 2.4A?