DS25CP104A: EQ and PE pins when used in SMBus Mode

Kawai

Guru 19775 points

Part Number: DS25CP104A

Hi Team,

I found following description in the pin descriptions.

In the case, when user wants to control EQ and PE through registers, how can you override the pin settings ?

Is this description a typo ?

Best Regards,

Kawai

over 6 years ago

0 Lee Sledjeski over 6 years ago

TI__Mastermind 43795 points

Hi Kawai,

The table is correct. There is a register bit to override the EQ and PE pins. Until the register to override the pins is enabled, the external pin control is active. See Table 11 on page 16 of the datasheet.

Regards,

Lee

0 Kawai over 6 years ago in reply to Lee Sledjeski

Guru 19775 points

Hi Lee-san,

I had missed this table when I was checking. Thanks for the information.

Best Regards,
Kawai

Interface

Interface forum

DS25CP104A: EQ and PE pins when used in SMBus Mode