SN65HVDA195-Q1: SN65HVDA195 nWake permanent on GND

Matthias Terhorst

Part Number: SN65HVDA195-Q1

Team

is it allowed to tie the Pin nWake of the device SN65HVDA195 permanent (hard-wired) to GND without using any resistor (no pull-up, no serial resistor,...) ?

Best Regards

Matthias

over 6 years ago

0 Eric Hackett over 6 years ago

TI__Guru 65932 points

Matthias,

Tying this pin to ground won't allow the device to go into Sleep mode since it is an active low, and not an edge transition, is this okay? If the user doesn't want to use the local WAKE feature, tying it directly to VSUP would be okay, and this will consume less current from the battery than tying it directly to GND anyway.

Please let me know if you have any other questions or concerns.

Regards,

0 Eric Hackett over 6 years ago in reply to Eric Hackett

TI__Guru 65932 points

Matthias,

I just wanted to make you aware that I made an edit to my post, so I'm bumping the thread to assert a notification.

Regards,

Interface

Interface forum

SN65HVDA195-Q1: SN65HVDA195 nWake permanent on GND