CCS/LMH1297EVM: SigCon architect USB connectivity

Charles Harris

Part Number: LMH1297EVM
Other Parts Discussed in Thread: USB2ANY, LMH1297

Tool/software: Code Composer Studio

Hi,

I am using a LMH1297EVM and I am trying to get SigCon to work on it but SigCon is saying "There are no USB2ANY interfaces detected." The computer recognizes the board as a usb input device. When I have the board plugged, the LED doesn't flash, it just stays solid green. I saw on another forum post with the same question but different board that this means I need to reload the firmware onto the evm.

over 4 years ago

0 Nasser Mohammadi over 4 years ago

TI__Guru* 88915 points

Hi Charles,

Could you please use USB2ANY software to make sure MSP430 controller is programmed properly. You ca install this software and then plug in LMH1297EVM. This software would update MSP430 on LMH1297EVM.

Regards,, Nasser

0 Charles Harris over 4 years ago in reply to Nasser Mohammadi

Prodigy 210 points

Nasser,

We have updated the MSP430 software, but SigCon is still not working. We need the Profile design files for the LMH1297EVM to load into SigCon as described in the forum linked below.

https://e2e.ti.com/support/interface/f/138/t/774506?tisearch=e2e-sitesearch&keymatch=LMH1297

Thanks,

Charlie

0 Nasser Mohammadi over 4 years ago in reply to Charles Harris

TI__Guru* 88915 points

Hi Charles,

Profile for the LMH1297EVM is on the LMH1297 secured folder. Please access this folder to get this utility. Alternatively you can send me email at Nasser.mohammadi@ti.com

Regards,, Nasser

Interface

Interface forum

CCS/LMH1297EVM: SigCon architect USB connectivity