• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 32 subscribers
  • Views 110 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS90UB953-Q1EVM: Settings for interface

Revanth A1
Intellectual 300 points
Part Number: DS90UB953-Q1EVM
Other Parts Discussed in Thread: DS90UB954-Q1EVM

Hello,
we are trying to use DS90UB953-Q1EVM and DS90UB954-Q1EVM for converting MIPI->FPD-Link->MIPI , Our 2MP 2Lane RAW10 MIPI CSI-2 camera sensor attached to the serializer has its own 24Mhz clock and has i2c address of 0x36, In the Deserializer board using Analog Launchpad software configured settings as shown below, To configure my sensor from deserializer board any register needs to be changed?

  • 0
    TI__Genius 11340 points

    Hello,

    To configure the sensor, following the below steps to set the sensor ID and alias. And use the alias ID to write to the sensor.

    - Des reg 0x4C: Select the right RX port to write

    - Set/Check real I2C addresses

    - Reg 0x5B SER DEVICE ID: Set the real serializer I2C address. This is typically loaded already

    - Reg 0x5D SlaveID[0]: Set the real CMOS sensor I2C address

    - Reg 0x5C SER_ALIAS_ID: Set the alias serializer I2C address

    - Reg 0x65 SLAVE_ALIAS_ID[0] (camera alias ID): Set the alias CMOS sensor I2C address