TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] What are the different I2C Buffer Direction Control Mechanisms?

    Tyler Townsend
    Tyler Townsend
    Other Parts Discussed in Thread: TCA9517A , TCA9517 , TCA9511A , TCA4307 FAQ: Logic and Voltage Translation > IxC >> What are the different I2C Buffer Direction Control Mechanisms ? I2C buffers implement direction control mechanisms to determine which…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83822I: Does Oscillator Clock or other external clock source to XI pin need to be stable before PHY power?

    Hillman Lin
    Hillman Lin
    Part Number: DP83822I Tool/software: Yes, Clock in external clock mode shall be available at power ramp. If not available, it is recommended to hold RESET_N low and release it at least 100 us aer external clock is stable.
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] What is the "VILC" Electrical Spec in I2C Buffers?

    Tyler Townsend
    Tyler Townsend
    Other Parts Discussed in Thread: TCA9517A Part Numbers: TCA9517A , TCA9517 , TCA9509 FAQ: Logic and Voltage Translation > IxC >> What is the "VILC" Electrical Spec in I2C Buffers ? VILC = Input LOW Contention Voltage VILC is the internal voltage…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] What is a buffered LOW?

    Tyler Townsend
    Tyler Townsend
    Part Number: TCA9517 Other Parts Discussed in Thread: TCA9617B FAQ: Logic and Voltage Transla tion > IxC >> What is a buffered LOW ? A "buffered LOW" is the output voltage of the buffer when a low voltage input (VIL) is present on the input. This…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] SN65DSI8x Programming Tools

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: SN65DSI84 Other Parts Discussed in Thread: SN65DSI85 , SN65DSI83 , SN65DSI86 Tool/software: DSI Tuner Tool (SN65DSI83, SN65DSI84, SN65DSI85): This tool is used to translate the video timings of the LVDS panel bein used to register values…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB211A: How does a USB2 redriver boost the signal that passes through it?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB211A Tool/software: How does a USB2 redrivers boost the signals that come through it? I do not understand how this is possible since some redrivers do not need to be directly incorporated into the trace to process and boost the signal…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB211A: Why do some USB2 redrivers not need to be directly integrated?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB211A Other Parts Discussed in Thread: TUSB217A , TUSB214 , TUSB211 , TUSB216 , TUSB212 Tool/software: Some USB2 redrivers do not need to be directly integrated into a trace, and can just be placed over the trace. Why is that? Won't this…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS280DF810EVM: How to reflash USB2ANY for use with SigCon Architect GUI

    Lucas Wolter
    Lucas Wolter
    Part Number: DS280DF810EVM Other Parts Discussed in Thread: USB2ANY Tool/software: In this FAQ, I will explain how to reflash a USB2ANY device to interface between an EVM board and SigCon Architect GUI. This FAQ applies to any EVM which is controlled…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS125DF111: How to capture a full eye opening measurement using SMBus registers

    Lucas Wolter
    Lucas Wolter
    Part Number: DS125DF111 Other Parts Discussed in Thread: DS110DF111 , , DS100DF410 , DS110DF410 , DS125DF410 Tool/software: In this FAQ, I will cover the SMBus register sequence to capture a full eye opening measurement. This FAQ applies to the following…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS320PR810: Using EyeScan to Optimize CTLE Setting on Your PCIe Redriver

    Nick Peabody
    Nick Peabody
    Part Number: DS320PR810 Tool/software: Hi All, Texas Instruments uses PCIe redrivers to perform signal conditioning on medium to upper medium loss systems. The redriver is effective in a wide variety of systems with losses ranging from -36dB to -56dB…
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    About firmware update of TUSB3210 0 Locked

    678 views
    1 reply
    Latest over 10 years ago
    by Roberto Diaz
  • Not Answered

    TCA6416A input registor read data problem 0 Locked

    2231 views
    12 replies
    Latest over 10 years ago
    by Jonathan Valdez
  • Not Answered

    C# example for HID class host USB for MSP430F6636 0 Locked

    710 views
    0 replies
    Started over 10 years ago
    by Raghvendra Singh
  • Answered

    SN65HVDA100-Q1 / LIN dc-input voltage(VLIN) 0 Locked

    783 views
    1 reply
    Latest over 10 years ago
    by Casey McCrea
  • Answered

    HI Would like to check if TI has a solution for DSI to DVI_I? 0 Locked

    287 views
    1 reply
    Latest over 10 years ago
    by Joseph Wu
  • Answered

    What event triggers PCD bit of TUSB7420? 0 Locked

    386 views
    1 reply
    Latest over 10 years ago
    by Elias Villegas M.
  • Suggested Answer

    1394b - What's difference between versions of TSB81BA3 d / e and G4 code? 0 Locked

    1581 views
    1 reply
    Latest over 10 years ago
    by Elias Villegas M.
  • Answered

    ONET85xx series TIA for 1 pF APD 0 Locked

    1254 views
    1 reply
    Latest over 10 years ago
    by Alex Davidson
  • Not Answered

    TUSB8040A System Wakeup Issue 0 Locked

    765 views
    7 replies
    Latest over 10 years ago
    by JMMN
  • Answered

    High-speed linear/switched laser driver 0 Locked

    645 views
    1 reply
    Latest over 10 years ago
    by Alex Davidson
  • Suggested Answer

    SN65LVDS352 / output impedance 0 Locked

    402 views
    1 reply
    Latest over 10 years ago
    by Miguel Robertson
  • Answered

    power outside for DP83848VYB 0 Locked

    420 views
    3 replies
    Latest over 10 years ago
    by Patrick OFarrell
  • Not Answered

    LM8323 Question 0 Locked

    323 views
    0 replies
    Started over 10 years ago
    by Masa_0000
  • Answered

    SN65HVD102 RX, TX Pin 0 Locked

    2522 views
    8 replies
    Latest over 10 years ago
    by Van-Ngoc Nong
  • Answered

    TPS65982 (USB 3.0 signal not worked) 0 Locked

    1572 views
    9 replies
    Latest over 10 years ago
    by Carol Chen
  • Answered

    WEBENCH Interface Designer - OUT_PT1 waveform 0 Locked

    860 views
    4 replies
    Latest over 10 years ago
    by Kawai
  • Answered

    SN65HVD11 Senak voltage from signal line to Vcc line at not supplying Vcc. 0 Locked

    1791 views
    5 replies
    Latest over 10 years ago
    by masahiko shimizu
  • Not Answered

    DS90CR285 output jitter 0 Locked

    855 views
    5 replies
    Latest over 10 years ago
    by Michael Lu (Santa Clara)
  • Answered

    Need a suitable chip for 8,8,8-bit RGB pixels to DisplayPort transmission 0 Locked

    796 views
    4 replies
    Latest over 10 years ago
    by Diego Cortes
  • Answered

    TPL7407L current ability 0 Locked

    959 views
    3 replies
    Latest over 10 years ago
    by Michael J Schultis
<>