TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Interface

Interface

Interface forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Interface support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search interface IC content or ask technical support questions on everything from ESD protection to interfacing with USB, Ethernet, and HDMI. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] Linear vs. Limited Mode in Redrivers

    Vishesh Pithadiya
    Vishesh Pithadiya
    Part Number: TDP1204 Other Parts Discussed in Thread: TMDS1204 Linear Mode: In linear mode the data received from the GPU’s transmitter is the data that will be sent out of the TX end of the redriver. This means that the GPU’s voltage swing, pre-emphasis…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TUSB216I: How do you create a system with a 10 meter passive cable using a USB2 redriver?

    Ryan Kitto
    Ryan Kitto
    Part Number: TUSB216I Other Parts Discussed in Thread: TUSB217A , TUSB216-Q1 , , TUSB216 , TUSB211A I want to create a system that can support USB2 while utilizing a 10 meter passive cable. Which redriver(s) should I use, and how should they be configured…
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] USB-C CC and PD controller differences

    Shane Hauser
    Shane Hauser
    Do I need to use a CC controller or PD controller for my USB-C application?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] How to control VBUS on a USB-C port

    Shane Hauser
    Shane Hauser
    Other Parts Discussed in Thread: TUSB320 How do I control the VBUS on my USB-C downstream facing or dual-role port?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] TDP1204: When to AC or DC couple the HDMI 2.1 output?

    Zach Dryer
    Zach Dryer
    Part Number: TDP1204 Up until HDMI 2.1, source output AC coupling was not clearly defined. However, now with HDMI 2.1 AC coupling is clearly defined. However, how can the designer determine when to AC or DC couple the HDMI 2.1 output?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] Potential TI Solutions for Video Protocol Conversion

    Zach Dryer
    Zach Dryer
    What potential solutions does TI offer for video protocol conversion?
    • Answered
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TG720S-Q1: Where can I find the latest Linux Drivers for DP83TG720 and DP83TG812/3/4?

    Melissa Chang
    Melissa Chang
    Part Number: DP83TG720S-Q1 Attached are the latest drivers tested on Kernel 5.10: GitHub - TexasInstruments/ti-ethernet-software: Repository for Ethernet PHY drivers for Linux and RTOS. The DP83TC812 driver can be used for the DP83TC813 and DP83TC814…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DS160PR410: Difference Between IBIS-AMI versus IBIS Modeling

    Nasser Mohammadi
    Nasser Mohammadi
    Part Number: DS160PR410 Other Parts Discussed in Thread: DS160PR810 , LMH0340 IBIS stands for Input/Output Buffering Information Specifications while AMI stands for Algorithm modeling Interface. In short, IBIS is used to describe analog behavior of…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC812S-Q1: My PHY won't link up

    David Creger
    David Creger
    Part Number: DP83TC812S-Q1 Link status is shown in register 0x1 bit[2]. Link failing to show as up can be caused by many issues. Please see the following debug guide which walks through several of the possible causes and fixes. Specifically see section…
    • over 1 year ago
    • Interface
    • Interface forum
  • [FAQ] DP83TC813S-Q1: How to output LED1 signal on pin 14

    David Creger
    David Creger
    Part Number: DP83TC813S-Q1 By default, pin 14 of the DP83TC813 will output the CLKOUT signal. To instead have the LED1 signal on pin 14, write to the below registers. 0x045F = 0x000F 0x0452 = 0x0000 0x0451 = 0x0009
    • over 1 year ago
    • Interface
    • Interface forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Suggested Answer

    TCA9548A: About TCA9548A operate 1.8V 0 Locked

    241 views
    1 reply
    Latest over 6 years ago
    by BOBBY
  • Answered

    DS25BR100EVK: Evaluation board seems to be defective 0 Locked

    961 views
    13 replies
    Latest over 6 years ago
    by Thong Nguyen62
  • Answered

    DS90UB954-Q1EVM: Data type packet header field is not as expected after deserialization 0 Locked

    1303 views
    8 replies
    Latest over 6 years ago
    by Christopher Buck24
  • Answered

    DS90CF388A: 4K resolution 0 Locked

    387 views
    1 reply
    Latest over 6 years ago
    by Casey McCrea
  • Suggested Answer

    USB-C-PD-DUO-EVM: issue with embedded FTDI -> no config in EEPROM 0 Locked

    292 views
    1 reply
    Latest over 6 years ago
    by Eric Beljaars
  • Suggested Answer

    Linux/DP83848C: dp83848 works with linux 4.13 but not with 4.15 and later 0 Locked

    1039 views
    5 replies
    Latest over 6 years ago
    by Hung Nguyen92
  • Suggested Answer

    DP83TC811S-Q1: Schematic Review 0 Locked

    183 views
    1 reply
    Latest over 6 years ago
    by Hung Nguyen92
  • Answered

    DS90UH940N-Q1: Proper Pulldown Resistor value and TVS-Diode selection guide 0 Locked

    324 views
    1 reply
    Latest over 6 years ago
    by Casey McCrea
  • Answered

    DS90UB933-Q1: test pattern from DS90UB933-Q1? 0 Locked

    334 views
    2 replies
    Latest over 6 years ago
    by Dennis Fu
  • Suggested Answer

    DS90UB964-Q1: ds90ub964-q1 data 0 Locked

    212 views
    1 reply
    Latest over 6 years ago
    by Jiashow Ho
  • Suggested Answer

    TUSB211: TUSB211RWBR TJ & TC 0 Locked

    267 views
    1 reply
    Latest over 6 years ago
    by Brian Zhou
  • Suggested Answer

    HD3SS215: 2:1 HDMI switch for 8K/60Hz TV 0 Locked

    358 views
    1 reply
    Latest over 6 years ago
    by David (ASIC) Liu
  • Answered

    SN65LVDS4: SN65LVDS4: BXL tool is not creating a 3D file 0 Locked

    192 views
    1 reply
    Latest over 6 years ago
    by Ikechukwu Anyiam
  • Answered

    TCAN1042H-Q1: TCAN1042 SON package device variance. 0 Locked

    641 views
    4 replies
    Latest over 6 years ago
    by Eric Hackett
  • Answered

    question for document snla158 0 Locked

    278 views
    6 replies
    Latest over 6 years ago
    by Nasser Mohammadi
  • Suggested Answer

    TLK1221: I need TLK1221 verification model (verilog,vhdl,sv,c) 0 Locked

    573 views
    3 replies
    Latest over 6 years ago
    by Ikechukwu Anyiam
  • Answered

    PCIxx12 Integrated FlashMedia Controller driver for Windows 10 32 bit 0 Locked

    6208 views
    1 reply
    Latest over 6 years ago
    by Ikechukwu Anyiam
  • Suggested Answer

    SN65HVD50: SN65HVD50 0 Locked

    554 views
    7 replies
    Latest over 6 years ago
    by Hao L
  • Suggested Answer

    TUSB8041: Questions for TUSB8041 Powering On Timing Issues 0 Locked

    725 views
    1 reply
    Latest over 6 years ago
    by JMMN
  • Answered

    DS92LV010A: LVDS to TTL 0 Locked

    920 views
    4 replies
    Latest over 6 years ago
    by Ikechukwu Anyiam
<>