Texas Instruments (TI) Isolation support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search isolation IC content or ask technical support questions on everything from digital isolators and isolated transceivers to transformer and isolated drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] How to connect SPI MCU to multiple isolated SPI nodes?

    Other Parts Discussed in Thread: ISO7741 , ISO6741 How to connect SPI MCU to multiple isolated SPI nodes?

  • [FAQ] How to calculate the maximum SPI speed supported by a digital isolator?

    Other Parts Discussed in Thread: ISO7741 How to calculate the maximum SPI speed supported by a digital isolator?

  • [FAQ] ISOW7841: Can I connect VISO outputs of two or more ISOW7841 devices directly in parallel to get higher output current than the current supported by a single device (130mA)?

    Part Number: ISOW7841 Can I connect VISO outputs of two or more ISOW7841 devices directly in parallel to get higher output current than the current supported by a single device (130mA)?

  • [FAQ] ISO1410: What is the relationship between cable length and data rate for TI’s isolated RS-485 transceivers?

    What is the relationship between cable length and data rate for TI’s isolated RS-485 transceivers?

  • [FAQ] ISO7041: What is the FIT data for this part?

    Part Number: ISO7041 What is the FIT data for the ISO7041?

  • [FAQ] SN6505B-Q1: Driving waveform distortion at high ambient temperature

    Part Number: SN6505B-Q1 Other Parts Discussed in Thread: SN6501 Hello team, My customer put SN6505B-Q1 at 85°C chamber then the output voltage became abnormal. Please find below waveforms. SN6505B-Q1 is put at current monitoring board and closed…

  • [FAQ] Can I connect two unidirectional channels on digital isolators to achieve a bidirectional channel for I2C communication?

    Can I connect two unidirectional channels on digital isolators to achieve a bidirectional channel for I2C communication?

  • [FAQ] Why is the logic LOW level output voltage, VOL1, up to 0.8V on Side1 of the ISO1540 and ISO1541 bidirectional I2C isolators?

    Other Parts Discussed in Thread: ISO1541 , ISO1540 Why is the logic LOW level output voltage, V OL1 , up to 0.8V on Side1 of the ISO1540 and ISO1541 bidirectional I2C isolators?

  • [FAQ] What are the recommended logic HIGH and LOW input voltage levels that can be applied to the isolated I2C devices, ISO1540 and ISO1541?

    Other Parts Discussed in Thread: ISO1541 , ISO1540 What are the recommended logic HIGH and LOW input voltage levels that can be applied to the isolated I2C devices, ISO1540 and ISO1541?

  • [FAQ] What is the current consumption of the isolated I2C devices, ISO1540 and ISO1541?

    Part Number: ISO1541 ISO1540 Other Parts Discussed in Thread: ISO1540 What is the current consumption of the isolated I2C devices, ISO1540 and ISO1541?

View FAQ threads